Stock exhaust diameter? DIY muffler delete pending
1 Attachment(s)
I am planning on doing a DiY muffler delete, and was wondering what the stock exhaust diameter is right at the last hanger before the y-pipe. Does anyone know the size of the piping at the exact location indicated in the pic? Any help would be appreciated.
For the record, that's not my exhaust in the picture or I would already have my answer lol |
1 Attachment(s)
I don't have that section anymore. However, I still have my resonator and I just went out to the garage to measure the ID. What I measured is 3 ⁱ /₂" inlet & 2 ⁵/₈" outlet. So I would assume that ID of that section of pipe is the same as the resonator outlet.
(Not my pict either) Lou |
the IS-F drones terribly between 2-3000rpm without the stock muffler. Sounds good at WOT though
|
Lou,
do you know what size the stock muffler outlets are? |
^^^^Sorry I don't have those any more. Will probably have access to a stock set in the next month or so, but that's too late for you. But, I'm curious, why would that dimension be important to you?
Lou |
He probably wants to piece together a slip fit muffler delete pipe to connect to the rear y split where he'll cut it a the point he is needing the dimension of.
|
^^^^Don't think so, he's asking the size of the muffler outlet pipes:confused:
Lou |
Originally Posted by lowrideraz
(Post 8856797)
^^^^Don't think so, he's asking the size of the muffler outlet pipes:confused:
Lou https://cimg4.ibsrv.net/gimg/www.clu...23041b963d.jpg ~ Joe Z |
Originally Posted by Joe Z
(Post 8856847)
|
Originally Posted by lowrideraz
(Post 8856797)
^^^^Don't think so, he's asking the size of the muffler outlet pipes:confused:
Lou |
^^^^We're all guessing here:uh: Can't be that, because I gave him the inlet/outlet dimensions of the resonator. Why don't we wait for him to specify?
Lou |
Guess no one else realizes..
The Original Poster #1 / thread starter is "Spooled" and "imp0rted1" is the one asking for exhaust tip outlet sizes ;) ;) Joe Z |
1 Attachment(s)
I want to say these are the tips, so 2.25 in. 3.5 in outlet, 4.5 in length
Attachment 495279 http://www.summitracing.com/parts/mpe-35125/overview/ |
I was asking about the diameter of the pipe at the exact location in which the arrow is pointing. I was planning on cutting the muffler section, right at the area indicated in the original post, and welding a turndown so the exhaust isn't pointing directly towards to read diff.
I do not care to know the size of the stock muffler tips lol |
Originally Posted by Spooled
(Post 8867569)
I was asking about the diameter of the pipe at the exact location in which the arrow is pointing. I was planning on cutting the muffler section, right at the area indicated in the original post, and welding a turndown so the exhaust isn't pointing directly towards to read diff.
I do not care to know the size of the stock muffler tips lol I neglected to read your post and I was responding to another member. Anyhow, I plan on deleting my mufflers and 2nd cat this week and I will have my exhaust shop do something about that flat part of the axleback. Hope I gain some power if any but looking for a good shift in the overall sound. Stock is too quiet for me |
All times are GMT -7. The time now is 01:49 PM. |
© 2024 MH Sub I, LLC dba Internet Brands