G9N

iTrader: (2)

I love the look that the TOMS front splitter gives! However, my car is a DD and I'm going to also be switching to BC coils and lowering it a little bit. Have you guys had any mishaps with your splitter? Do you find it scraping a lot? Also, have any of you tracked your car with it? How's it holding up? Sorry for the million questions but the last thing I want to do is watch $1400 break into broom stick pieces or look like a $13.99 piece after wear and tear.

I tried searching the forums but nothing populated really besides peoples sigs. Sorry if this has been discussed before.

yjk1975

I have had it on for I think about 3 to 4 months. I am dropped on BC Coils and have scraped 1 time. I am just very careful.

ISF4life

iTrader: (30)

Not to worry, u can always go hardware store and get some velcro and tape it underneat to prevent scraping . i have it over 2 yrs now and its find sometime u scrape a bit but just use black marker to ease it out lolz. its Tom's front lip :P

LOLM3

iTrader: (3)

I used to use velcro but it got torn up, now I use those adhesive sliders you use under furniture for hardwood floor and it works really well and it's not noticeable.

Luis3rD

I've had my lip for 3 months and so far no scrape I'm also lowered on BC and use my car as a DD.

HellaInc

iTrader: (5)

Depends how low you have the car really. I am slammed on my F and I am contemplating on getting the toms lip also. I would definately have to raise the front if I did because I already scrape over almost every driveway

darbs242

iTrader: (5)

I have the downforce lip and am lowered at least an inch in the nose and rarley scrape and I'm in upstate ny

LiLS

iTrader: (7)

my car is slammed to the ground and its scrapes all the time but its held up

Isfast

iTrader: (13)

I used skateboard slip tape. I installed it in 2011 and it is holding up well.

http://www.skatesonhaight.com/Yatz-S...e-p/yatzst.htm

I covered the entire bottom of my Tom's lip. Takes time.

I stuck a piece on to the bottom of a heavy weight and dragged it around the concrete outside. The thing is so slippery it is amazing and very little wear.

G9N

iTrader: (2)

Did any of you install your own? If you did, how hard was the install? Would you recommend having a body shop install it?

Lastly does anyone know what carbon fiber pattern TOMS uses?

ULTSISF

iTrader: (2)

This sounds like a good idea. Thanks

jdmSW20

iTrader: (12)

car looks sick on the VSTX man, i always wanted a set myself