Needed: IS-F in AZ for race header prototyping
#17
Advanced
iTrader: (3)
Yeah the F market is significantly smaller than the IS350 market so I would assume that would make the cost considerably more. I think at best we could maybe see an initial group buy price right at a 1000 with maybe a regular price of like 1200 but hey I am just speculating and hoping like anyone else.
#20
Final pricing isn't set, but they will be around $1300 with the JetHot Polished ceramic coating.
We haven't decieded yet what will be done about the dipstick tube. We adjusted the stock one to fit and made a new bracket on our prototype. We may include a new one in the kit which would increase the price a bit.
The headers will come standard with parllel merge collectors, Lexus 60mm outlet gaskets, O2 sensor plug in wiring extensions, weld-on rear O2 bungs to keep the CEL off and JetHot brand Ceramic Coatings.
-Paul
We haven't decieded yet what will be done about the dipstick tube. We adjusted the stock one to fit and made a new bracket on our prototype. We may include a new one in the kit which would increase the price a bit.
The headers will come standard with parllel merge collectors, Lexus 60mm outlet gaskets, O2 sensor plug in wiring extensions, weld-on rear O2 bungs to keep the CEL off and JetHot brand Ceramic Coatings.
-Paul
#23
Why are you testing with an aftermarket intake? Which one are you using?
#24
Lexus Champion
Those are some pretty impressive gains with a stock exhaust. Im sure an aftermarket setup w/o secondary cats would yield higher numbers. Have you figured out a way to prevent a CEL without the primary cats? Keep up the good work, I am looking forward to the finals numbers and price.
Last edited by LexISguy; 02-10-11 at 10:19 AM.
#27
Lexus Champion
I spoke with Paul and he mentioned they were still doing some final testing and shooting for a March release with the final price and numbers. He was very informative and looking forward to the final results.