Review of Aerotect rear reflector film
09-21-09, 09:04 AM
#32
^^^
GOOD STUFF! I received 2 versions from Jason as well, but have not gotten a chance to put them on yet. Promising though, judging from your new pics! Damn they look good on black! ESP with that sexy sexy Wald Trunk!
Mind posting side or angle pics showcasing it a bit more?
GOOD STUFF! I received 2 versions from Jason as well, but have not gotten a chance to put them on yet. Promising though, judging from your new pics! Damn they look good on black! ESP with that sexy sexy Wald Trunk!
Mind posting side or angle pics showcasing it a bit more?
Neither, they're "blackout". Aerotect might have removed them from their site until this was resolved, so I think if they're not on there they will put them back when they see this thread. I emailed Jason as well.
09-21-09, 09:20 AM
#34
Former Sponsor
Glad they fit!
It was the strangest thing actually... I went and did a redesign at a local dealership, and cut the piece and left it at the shop. One day when I wasn't around Joe Z came in and Francisco tried to test fit the one I made, and it was about 1/4" to big all the way around. There must be two sizes out there... we just don't know why.
Anyhow, we will be including both sets with each order just to be sure that everybody gets one that fits.
Thanks again for the patience,
Jason
It was the strangest thing actually... I went and did a redesign at a local dealership, and cut the piece and left it at the shop. One day when I wasn't around Joe Z came in and Francisco tried to test fit the one I made, and it was about 1/4" to big all the way around. There must be two sizes out there... we just don't know why.
Anyhow, we will be including both sets with each order just to be sure that everybody gets one that fits.
Thanks again for the patience,
Jason
09-21-09, 09:25 AM
#35
Lexus Fanatic
iTrader: (10)
Join Date: Nov 2004
Location: Under an IS F since 2008
Posts: 13,446
Received 1,058 Likes
on
586 Posts
Glad they fit!
It was the strangest thing actually... I went and did a redesign at a local dealership, and cut the piece and left it at the shop. One day when I wasn't around Joe Z came in and Francisco tried to test fit the one I made, and it was about 1/4" to big all the way around. There must be two sizes out there... we just don't know why.
Anyhow, we will be including both sets with each order just to be sure that everybody gets one that fits.
Thanks again for the patience,
Jason
It was the strangest thing actually... I went and did a redesign at a local dealership, and cut the piece and left it at the shop. One day when I wasn't around Joe Z came in and Francisco tried to test fit the one I made, and it was about 1/4" to big all the way around. There must be two sizes out there... we just don't know why.
Anyhow, we will be including both sets with each order just to be sure that everybody gets one that fits.
Thanks again for the patience,
Jason
I just had a thought.. They may have changed the part# or size between 2008's & 2009's..
I will try to dig up some info on this..
Joe Z
09-21-09, 09:34 AM
#36
Former Sponsor
See you later this week Joe!
I'll be placing my order shortly 
Thread
Thread Starter
Forum
Replies
Last Post
