When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I just got my 19x8.5 19x10 CVT's installed with the recommended 235/35 265/30 tires. I'm lowered on S.Techs. It sounds like im hitting on the rear left seam where the bumper attaches to the frame.
It doesn't seem like there's anything to roll. Anyone have a remedy for this?
It could be the size tire you're running. I have 20" CV5 with RS*R Down Springs which are similar drop and don't rub but I have 225/30/20 and 255/30/20.
your problem might be that falkens run on the large side.
Someone had falkens on a set of velgens which were 10.5 wide dropped on teins and they didn't rub. The falkens aren't as tapered as stock but they also aren't fat.
Anyone think I might have gotten the wrong offset?
It could be the size tire you're running. I have 20" CV5 with RS*R Down Springs which are similar drop and don't rub but I have 225/30/20 and 255/30/20.
RSR Downs and TEIN S.Techs not similar. S.Techs are a lot lower IMO.
I rub too, I have a vossen 20x10.5 in the rear with 255/30/20 and I am also running the tein s springs. I had to have the fenders pulled a little so that they wouldn't rub.
I drove it around town trying to get it to rub, and if im not careful going over speed bumps, the fronts hit real hard. Im left with these burn marks from my tires.
I rub too, I have a vossen 20x10.5 in the rear with 255/30/20 and I am also running the tein s springs. I had to have the fenders pulled a little so that they wouldn't rub.
Do the fenders look normal after the pull? This may be my only option since my alignment specs aren't that off from being lowered.
07-16-14, 05:00 PM
Anyone else rubbing on Vossen's?
[/IMG]
[/IMG]
