Trouble with OBD Evap Test
#1
Lead Lap
Thread Starter
Trouble with OBD Evap Test
I've searched and searched the threads but still having trouble.
My car was in storage for a year and the battery was disconnected and I need a smog check.
I've done almost a week of driving with about ~400 miles and the EVAP test is still not running. I need to get this registered ASAP! I went through the different drive cycles but it's not working.
I'd like clarification if I should be following the "hold revs at 3k RPM for 10 seconds" or "Hold steady speed of 55mph for 10 minutes" procedure. I've done both after following cold starts and everything.
Frustrating!!!! Any advice?
My car was in storage for a year and the battery was disconnected and I need a smog check.
I've done almost a week of driving with about ~400 miles and the EVAP test is still not running. I need to get this registered ASAP! I went through the different drive cycles but it's not working.
I'd like clarification if I should be following the "hold revs at 3k RPM for 10 seconds" or "Hold steady speed of 55mph for 10 minutes" procedure. I've done both after following cold starts and everything.
Frustrating!!!! Any advice?
Thread
Thread Starter
Forum
Replies
Last Post
pcroland
RX - 2nd Gen (2004-2009)
8
03-14-24 02:26 PM
spinscan
LS - 1st and 2nd Gen (1990-2000)
6
09-12-15 04:31 PM