rickdestik

It does matter in that when I have a TPMS failure, I would like to be able to tell which one it is.

derreckla

Any secret to this? I tried plugging in battery charger and lap top and I still get "Terminate Initialization by connecting TC and CG of the DLC3 for 30 seconds"

Any other ideas?

s3v3n

iTrader: (3)

Where did you buy OBD2 cable? Amazon, Ebay, China? That is the issue.

MikeFig82

iTrader: (13)

Discount tire will program TPS for free. I had a mobile tire shop install some Denso's on my new wheels. Turns out they forgot their tool too program. After work I just drove to DT the whole ordeal took a few minutes. I don't recall them asking for ID'S. It looks like the scan tool did all the work.

derreckla

Do the sensors have to be "activated"?

I just tried some generic ones on my wifes camry got the same error message, I ordered Corista mobile hopefully this will solve all my problems.

Thanks

MikeFig82

iTrader: (13)

On my Denso's they had a sticker. I think you add air to tire then release to initialize. I'm looking online if I find anything I'll post back here.

s3v3n

iTrader: (3)

OEM Denso comes activated. Others didn't but it's easy to activate them, just bring the psi down to less than 10 and they will wake up.

EEng

I got the Qwik Sensor from Napa and took the car to Discount Tire to replace the TPMS. They could not program it. Now I am trying to find a place to program it.

I have a Tech Stream cable. Where would I get the Tech Stream software?