Installing Tom's Rear Lip
 

I've just got my Tom's rear lip and planning to do the install soon. I know that the lip has to be screwed in from beneath and the wheel arch areas. As for the top bit that sits flush on the bumper, it seems that this is only held together with 3M tape.

Am I missing something, or is this it? Just thinking if that 3M tape strip that comes stuck onto the lip is strong enough to hold it together

any advice would be appreciated.

thanks

When I had mine on what was holding the whole lip was 3m tape. if I am not mistaken you dont need to screw it in cause u will have to drill a hole in the bumper

there is also a rubber strip thing that sits on the edge where the lip fits flush against the bumper, it seems to have been stuck on somehow with some sort of adhesive. However, some areas are not stuck and have come off. Can any suggest how I can stick that back on? or when i stick the lip onto the bumper with the 3m tape, will that strip go into place?

i was running my tom's rear lip with nothing but 3m tape and the push clips underneath for 4 months with no problems. i had a helluva time prying the rear lip off when i went to take it off...

my bodyshop used some sorta glue to glue the weather strip to the lip every 5 inches or so. i guess you could use like krazy glue?

any update on this? did all yoou guys use was the tape that came with the toms rear?

Clay the area(if possible), wipe with rubbing alcohol, spray the area with adhesion promoter and let sit for a little under a minute, then apply the lip with the double sided tape.

what do you guys think about walds front and toms rear??? 07 lexus isx50
or should i go with the gfx rear?

^I personally think it'll look good. I don't like the wald sides and rear. I like the tom's rear more.

I fully concur.

Would look good!

yea i would love the wald rear if it wasnt so big around the exhaust for the quad exhaust...toms would flow better. just dont want the front lip lower than the rear lip?? u guys kno what i mean?

^the wald rear comes un-cut for a dual exhaust. you have to modify it to fit the quad exhaust.

The only thing WALD makes nice is the front and trunk spoiler...
The rest, I'd go with Tom's!

pictures please?