IS3003o3

iTrader: (5)

^^ basically wired it the same as the pic below (only A1-A4). wired both pairs because the stock non ML subwoofer is dual voice coil.

bfedro427

So don't wire A5-A8

IS3003o3

iTrader: (5)

i've been messing around with the system all day and actually had to reconnect the 2 pairs from A1-A4 over to A5-A8. A1-A4 are connections for L&R Front speakers and A5-A8 are for the L&R Rear speakers

kumquatism

iTrader: (10)

Damn it I need to get rid of that picture. It's my picture, and I drew it to ask how I'm supposed to wire. And I found out it's not right. White/red should be A7-A8, and brown/pink should be A5-A6

IS3003o3

iTrader: (5)

i knew you drew it i've been through this thread over 10 times haha. you have ML though, right?

kumquatism

iTrader: (10)

No I have an 06 non ml

bfedro427

So what are people doing who don't have the orange wire for a remote turn on? I have looked multiple times, and there is definitely not a single orange wire in any of the harnesses. Really dont want to have to go back and run wires again from the cigarette lighter or whatever other people were doing. Any other remote turn on wires in the stock non ML amp?

Likwid XTC

iTrader: (5)

Use the cig lighter like some have

Mv350

iTrader: (23)

use a fuse tap, and use the driver side footwell fuse box. ive done multiple ISx50's doing this method

alee350

I'm not sure if this has been answered yet but I just got a LOC for my hifonics brutus amp and there are 2+ and 2- wires do i connect both to one of the either sets of + and - when taping into the factory sub wires? I have a non ml btw thank you!

2genIS

iTrader: (2)

tap like this:

brown + and green - -- one set
pink + and sky blue - -- one set

hopefully this answer your question

alee350

yes it did help alot gonna try taping today or tomorrow thanks alot!

MyIS350G

iTrader: (6)

Take too long to read all 12 pages:
can someone point me to the right direction, im on Non-ML how do i get the RCA audio from the amp to the stock deck?

kumquatism

iTrader: (10)

I'm a bit confused on your question , but our cars don't have an RCA output. You need some sort of converter that turns a speaker wire into an RCA out.

alee350

One more question how reliable are t taps? And what size shOuld I get for our wires?