When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I love the wheels!! Your car is very similar to mine, you should look into a roof spoiler!!
19 by 8.5 225/35/19 35 offset front
19 by 9.5 275/30/19 40 offset rear (I fitted a 35 offset and it rubbed on big dips - no fender rolling for me) (But damn did it look sexy lol)
How often do you go over big dips? I've got ET30 on the rear and my wheels are 19x10, on Tanabes but I'm on 265s I might go 275s next time. Still have room to drop but best to get higher profile then dropping.
hey guys i have a fitment question. im looking to pick up a 06 IS350 and i have a set of wheels and tires left from my 07 GS350 AWD, which is gone now in favor of a 16 RX
so heres the set up i was running
Volk Progressiv ME
19x8.5 +35 with 225/40/19
19x9.5 +35 with 255/35/19
Bridgestone Potenza S-04 Pole Position
The weirdo sizes are cause the GS had AWD and i wanted to keep the circumference difference as minimal as possible for the staggered fitment
will these sizes work on the IS without rubbing? tire calculations says that both front and rears are a 4% difference from stock so the speedo will be off a bit, but not a whole lot. However the overall height of the set will be 1" taller than stock,
and I dont plan on lowering if i get it. I really want to be able to use the setup cause they only saw 1 summer (barely 4000km's) and the TPMS sensors will program over to the IS.
So what chu guys think?
heres a pic of the wheels for reference (the color wasnt my choice, they were red when i bought them so theyre staying that way lol)
hey guys i have a fitment question. im looking to pick up a 06 IS350 and i have a set of wheels and tires left from my 07 GS350 AWD, which is gone now in favor of a 16 RX
so heres the set up i was running
Volk Progressiv ME
19x8.5 +35 with 225/40/19
19x9.5 +35 with 255/35/19
Bridgestone Potenza S-04 Pole Position
The weirdo sizes are cause the GS had AWD and i wanted to keep the circumference difference as minimal as possible for the staggered fitment
will these sizes work on the IS without rubbing? tire calculations says that both front and rears are a 4% difference from stock so the speedo will be off a bit, but not a whole lot. However the overall height of the set will be 1" taller than stock,
and I dont plan on lowering if i get it. I really want to be able to use the setup cause they only saw 1 summer (barely 4000km's) and the TPMS sensors will program over to the IS.
So what chu guys think?
heres a pic of the wheels for reference (the color wasnt my choice, they were red when i bought them so theyre staying that way lol)
You should be fine. The front might rub on full lock turns. The rear might rub on big bumps.
You should be fine. The front might rub on full lock turns. The rear might rub on big bumps.
picked up the whip on Friday, cleaned up (damn brake dust) and installed the wheels on sat! And good news no rubs in the front lock to lock and none in the back too!
Pulled the trigger on new wheels after I cracked one of my forged 3-piece barrels. went with 20" expecting to need a fender roll/pull, but fitment is PERFECT without it. 1mm of clearance when compressed, ran through the paces without any rubbing at all! Here's my setup:
Factory F-Sport Springs
20x8.5" +38 and 20x10.5" +42 Axe EX18 Gloss Black Wheels
245/30/20 tires in front, 275/30/20 in the back
Perfectly flush, perfect clearances, perfect FUNCTIONAL stance
No gap
05-04-17, 01:33 PM
