rusty turbo exhaust housing
#2
#3
Pole Position
Yeah, you'd have to bead blast the rust and then coat it with paint or powder coat. Ceramic coating (done properly) is quite expensive.
I would advise against just covering it w/ a turbo blanket but I've also seen plenty of rusty manifolds that were operating just fine. I'd coat it if it were me.
I would advise against just covering it w/ a turbo blanket but I've also seen plenty of rusty manifolds that were operating just fine. I'd coat it if it were me.
#4
Yeah, you'd have to bead blast the rust and then coat it with paint or powder coat. Ceramic coating (done properly) is quite expensive.
I would advise against just covering it w/ a turbo blanket but I've also seen plenty of rusty manifolds that were operating just fine. I'd coat it if it were me.
I would advise against just covering it w/ a turbo blanket but I've also seen plenty of rusty manifolds that were operating just fine. I'd coat it if it were me.
Thread
Thread Starter
Forum
Replies
Last Post
vindedreal
General Classifieds
1
04-18-10 11:38 AM
yauser
SC400 / 300 Classifieds
2
09-07-08 10:16 AM