View Poll Results: Crawl / MTS - model year/trim upgrade survey
2010 - Base - Added Crawl
0
0%
2011 - Base - Added Crawl
0
0%
2011 - Premium (stock Crawl) - Added MTS
0
0%
2012 - Base - Added Crawl
0
0%
2012 - Premium (stock Crawl) - Added MTS
0
0%
2014 Base - Added Crawl
0
0%
2015 Base - Added Crawl
0
0%
2015 Premium - Added Crawl
0
0%
2016 Base - Added Crawl
0
0%
2016 Premium - Added Crawl
0
0%
2017 Base - Added Crawl
0
0%
2017 Premium - Added Crawl
0
0%
2017 Luxury - Added Crawl/MTS
0
0%
2018 Base - Added Crawl
0
0%
2018 Luxury - Added Crawl
0
0%
2019 Base - Added Crawl
0
0%
2019 Premium - Added Crawl
0
0%
2019 Luxury - Added Crawl
0
0%
2019 Luxury - Added Crawl/MTS
0
0%
Voters: 123. You may not vote on this poll
MOD: Crawl Control (CC) and Multi Terrain Select (MTS)
#646
Super Moderator
Thread Starter
#647
Intermediate
#648
Intermediate
Got the Crawl switch installed and calibrated tonight. I went with the @Nickk6 method of keeping the blanks for the top two buttons, and having "stealth crawl" under the guise of a DAC switch.
The following users liked this post:
Acrad (07-13-18)
#651
Intermediate
#653
Intermediate
Probably about an hour, but I had taken apart a lot of those parts before so I just dove right in. The lower kick panel below the box is a bit tricky and the clips are pretty tight. I didn't remove the whole thing - just enough to get the interior of the glove box out of the way so I could stick my hand in there to unbolt the old computer. Budget a couple hours if you haven't been in there already.
#654
Super Moderator
Thread Starter
The remote start install instructions are also a good tutorial for taking dash apart. The remote start module is installed to the right of the Driver Support ECU
https://www.clublexus.com/forums/att...t-ac6a39f2.pdf
https://www.clublexus.com/forums/att...t-ac6a39f2.pdf
#656
Got the MTS computer installed and the console switch swapped. Is there a trick to install the passenger kick panel? Also, I have not had a chance to calibrate for the new switch, would there be a problem driving the car before calibration?
#657
Super Moderator
Thread Starter
It should be fine driving without calibration. You just wouldn't be able to use DAC.
#658
I was able to put on the kick panel this morning. When I took it off, I removed the clip and forgot how it goes back on. I finally figured it out. I will try to calibrate it tonight.
#659
got the car calibrated but something weird is happening. The VDC light is on constantly. I try to activate the crawl control but the on/off switch does nothing. The sequence I use is to put the car in Neutral, put car in 4lo, then shift into Drive and turn on Crawl button but it does nothing. I might have to calibrate again. Has anyone ran into this before? MTS is recognized and I could set the car in different terrains.
#660
Super Moderator
Thread Starter
That sounds like an incomplete calibration. MTS will work separate from Crawl.