I recently purchased oem cross bars for my 2015 GX460. I could use some guidance on how the “J” hook on the front bar gets attached. I understand how the right side works but am struggling with the left side.
live watched videos, unfortunately they were non-oem cross bars, but the person was loosening the screws to remove the “J” hook to get it properly placed under the rail.
The oem directions make no mention of taking the piece apart in order for it to be seated properly.
Any advice would be appreciated. Ty

 

It's been so long since I've used them last couple of years I'm not sure. IIRC.. there is a front and back bar. Are you certain rear bar isn't being attached to front?

Instructions
https://lexusgxor.com/_media/general...ar_install.pdf

You might want to see if anything shows up in this thread

https://www.clublexus.com/forums/gx-...rack-bars.html

 

Thanks for your response. Yes, I’m sure I have the bars positioned correctly.

 

Positioning in same area outside of warning label area?

 

Based on what I remember, installing the OE crossbar was straight forward. Are you sure you got the right part?

 

I have removed and re-installed the cross-over bars multiple times on my 2015 GX. I will say, there is a bit of force required to get the front bar properly aligned, as I believe you have to angle it to install it and remove it.