Will FJ wheels fit a GX?
#16
Pole Position
Thread Starter
The install is really easy. I did it on my t4r limited wheels. The trick is to get them torqued correctly. Very low torque (IIRC it's in inch-lbs). My guess is the monkeys at the tire shops don't use a torque wrench on them, but I went to the trouble of doing it on mine. Good excuse to buy another torque wrench
Find something to slide between the side of the monitor and the rim so it doesn't rotate and come in contact w/the rim when you tighten the nut. I used an old wood ruler.
Find something to slide between the side of the monitor and the rim so it doesn't rotate and come in contact w/the rim when you tighten the nut. I used an old wood ruler.
Thanks
#17
Driver School Candidate
I hate to revive an old thread but I was curious if anyone had used the FJ plain black steel wheels on the GX470? It looks like most people could bolt on the TRD wheels just fine. I wasn’t sure if the steel wheels had the same bore size. I know the GX is a 108mm bore. Are the FJ stock steelies also 108mm?
#18
I hate to revive an old thread but I was curious if anyone had used the FJ plain black steel wheels on the GX470? It looks like most people could bolt on the TRD wheels just fine. I wasn’t sure if the steel wheels had the same bore size. I know the GX is a 108mm bore. Are the FJ stock steelies also 108mm?
Thread
Thread Starter
Forum
Replies
Last Post
ServiceGuy
GX - 2nd Gen (2010-2023)
1
10-27-14 03:45 PM