ClubLexus - Lexus Forum Discussion

ClubLexus - Lexus Forum Discussion (https://www.clublexus.com/forums/)
-   GS F (2016-present) (https://www.clublexus.com/forums/gs-f-2016-present-283/)
-   -   Dyno'd the GSF (https://www.clublexus.com/forums/gs-f-2016-present/880731-dynod-the-gsf.html)

NotnFsport Feb 14, 2018 07:59 PM

Dyno'd the GSF
 
Went to EAS in Anaheim. Tom's filter and Novel headers. Stock intake tube, stock mid pipe and stock mufflers.https://cimg3.ibsrv.net/gimg/www.clu...cbcc3a3580.jpg
https://cimg0.ibsrv.net/gimg/www.clu...ac22dd27b5.jpg

biggame Feb 15, 2018 08:54 AM

Sorry, had to turn your printout..Nice numbers by the way! Stock mid pipe and mufflers? What gear?

https://cimg4.ibsrv.net/gimg/www.clu...a8b87ebd8.jpeg


NotnFsport Feb 15, 2018 09:25 AM

No worries. After 141 views finally a comment lol. 6th gear and stock mid pipe and mufflers.

jadu Feb 15, 2018 09:48 AM

419whp, nice :thumbup:

talltrini1 Feb 15, 2018 09:50 AM

Do you have a stock baseline?

ISF4life Feb 15, 2018 09:53 AM

ahahhahah not bad :P

NotnFsport Feb 15, 2018 10:16 AM

I wish I did but ran out of time before installing the headers. I can only base it off other Cali GSF owners with stock dyno numbers.

biggame Feb 15, 2018 10:23 AM


Originally Posted by NotnFsport (Post 10113917)
No worries. After 141 views finally a comment lol. 6th gear and stock mid pipe and mufflers.

Steve @ EAS is great! Did you request 6th gear pull? Mine definitely was higher when I did even a 5th gear pull. I have been Dynoing
consistently in 4th gear except for the one I did in 5th gear. Dyno'd my complete Novel exhaust at EAS. Picked the only hot day, of course.
My #'s were slightly lower than yours with stock air box set up

JDMUSCLE Feb 15, 2018 12:06 PM

What is the 1 to 1 gear in this car?

419whp with intake and headers seem decent. Anyone have any idea what these cars do bone stock?

NotnFsport Feb 15, 2018 12:43 PM

bone stock is 390 ish and 6th gear is 1:1

TrevorR Feb 15, 2018 01:16 PM

Thats kind of what I would expect with just headers and its amazing how well these engines benefit from headers swap!

Although I would question the 390 whp. If we were to just go by the typical "20% drive train loss" that I always read and hear about. 390 rwhp would mean that the GSF has 480-490 BHP.

But then again, BHP is kinda of the average rating, some cars may be above that or below that!

NotnFsport Feb 15, 2018 07:07 PM

I googled stock GSF dyno and saw one video and they dyno'd 392 whp and another former member " Dyno'd the car today as EAS, with intake and mid pipe setup the car pulls 402HP AND 345LBFT " but its all relative because I don't know what gear they dyno'd in and weather conditions etc. And stock RCF's are anywhere between 362 to 392. Yes different car but same engine and tranny.

finny76 Feb 17, 2018 10:18 AM

So just with the headers & Intake you can roughly get a 20whp increase! That is pretty good IMO. I'm guessing that with a Full system & intake should be getting 425~430ish....

Htowncory Feb 20, 2018 10:14 AM

Very nice.
What is Novel doing for the downstream o2 sensors to make sure no check engine light comes on?

NotnFsport Feb 20, 2018 02:07 PM


Originally Posted by Htowncory (Post 10118717)
Very nice.
What is Novel doing for the downstream o2 sensors to make sure no check engine light comes on?

Thank you. Novel uses mechanical O2 simulators.


All times are GMT -7. The time now is 08:02 AM.


© 2026 MH Sub I, LLC dba Internet Brands