Polished takeda intake review!
#31
Your #1 Lexus Vendor
iTrader: (8)
Tanabe.. We have them in stock right now!
-Josh
-Josh
__________________
Your #1 Dealer for Aftermarket Performance Products
Orange County, CA
Email: info@merakiautoworks.com
Text/Call: 213 394 2886
Website: www.MerakiAutoworks.com
Your #1 Dealer for Aftermarket Performance Products
Orange County, CA
Email: info@merakiautoworks.com
Text/Call: 213 394 2886
Website: www.MerakiAutoworks.com
#33
Lead Lap
Just installed my Takeda intake as well. Sounds great!! Thanks to OP for the recommendation of getting that better clamp at Home Depot.
There are so many clips attached to the factory intake...make sure you disconnect those first. Total time of install was 1 hour...and I knew what I was doing. I could see 2 hours if you've never installed one of these.
Thanks to Josh at Meraki for the great deal!
There are so many clips attached to the factory intake...make sure you disconnect those first. Total time of install was 1 hour...and I knew what I was doing. I could see 2 hours if you've never installed one of these.
Thanks to Josh at Meraki for the great deal!
The following 2 users liked this post by jtrue28:
SHuerta11 (05-16-17),
TrevorTran (05-16-17)
#34
Your #1 Lexus Vendor
iTrader: (8)
Just installed my Takeda intake as well. Sounds great!! Thanks to OP for the recommendation of getting that better clamp at Home Depot.
There are so many clips attached to the factory intake...make sure you disconnect those first. Total time of install was 1 hour...and I knew what I was doing. I could see 2 hours if you've never installed one of these.
Thanks to Josh at Meraki for the great deal!
There are so many clips attached to the factory intake...make sure you disconnect those first. Total time of install was 1 hour...and I knew what I was doing. I could see 2 hours if you've never installed one of these.
Thanks to Josh at Meraki for the great deal!
-Josh
__________________
Your #1 Dealer for Aftermarket Performance Products
Orange County, CA
Email: info@merakiautoworks.com
Text/Call: 213 394 2886
Website: www.MerakiAutoworks.com
Your #1 Dealer for Aftermarket Performance Products
Orange County, CA
Email: info@merakiautoworks.com
Text/Call: 213 394 2886
Website: www.MerakiAutoworks.com
The following users liked this post:
TrevorTran (05-16-17)
The following users liked this post:
TrevorTran (05-16-17)
#36
Driver
Thread Starter
This is the video that got me to purchase the intake:
It was on an RC350 but it's the same intake on the same engine, and the noise difference between stock and Takeda blew me away!
The following users liked this post:
TrevorTran (05-17-17)
The following users liked this post:
MythicOne (12-24-17)
#40
Lead Lap
This is the one that I bought...which was what the OP recommended as well.
http://www.homedepot.com/p/Everbilt-...210757&cj=true
http://www.homedepot.com/p/Everbilt-...210757&cj=true
The following 2 users liked this post by jtrue28:
Boombai (06-27-17),
TrevorTran (06-27-17)
#41
Driver School Candidate
Installed mine couple days ago, sounds great and I recommend it just as much as everyone else!
Going to double check my vent tube hose now to make sure its still connected. It did seem a little easy to slide on during the install. A tighter butterfly clamp would add some piece of mind. Think I just found something to take up some time today
Going to double check my vent tube hose now to make sure its still connected. It did seem a little easy to slide on during the install. A tighter butterfly clamp would add some piece of mind. Think I just found something to take up some time today
The following users liked this post:
TrevorTran (06-27-17)
#42
Driver
Thread Starter
Installed mine couple days ago, sounds great and I recommend it just as much as everyone else!
Going to double check my vent tube hose now to make sure its still connected. It did seem a little easy to slide on during the install. A tighter butterfly clamp would add some piece of mind. Think I just found something to take up some time today
Going to double check my vent tube hose now to make sure its still connected. It did seem a little easy to slide on during the install. A tighter butterfly clamp would add some piece of mind. Think I just found something to take up some time today
The following 2 users liked this post by PDF84:
byungkuk (08-06-22),
TrevorTran (06-28-17)
#44
Your #1 Lexus Vendor
iTrader: (8)
__________________
Your #1 Dealer for Aftermarket Performance Products
Orange County, CA
Email: info@merakiautoworks.com
Text/Call: 213 394 2886
Website: www.MerakiAutoworks.com
Your #1 Dealer for Aftermarket Performance Products
Orange County, CA
Email: info@merakiautoworks.com
Text/Call: 213 394 2886
Website: www.MerakiAutoworks.com
#45
Intermediate
Have any of you guys with the Takeda installed noticed a chirping sound from the engine bay when the car is in drive and stopped or while you're reversing and turning the steering wheel? I had this issue and thought it was related to the steering wheel or something so I brought it to the dealership. They told me the cause was the Takeda intake and suggested I return it back to stock. I love how the Takeda sounds and feels so I really don't want to, but the chirping is really annoying.