12-16-14, 12:42 PM
Last edit by: IB Advertising
See related guides and technical advice from our community experts:
Browse all: Lexus IS Engine and Powertrain Guides
- Lexus IS GS: Exhaust System Reviews
Reviews and comparisons of top products
Browse all: Lexus IS Engine and Powertrain Guides
PTS-Joe Z Series Dual Exhaust System & Joe Z Intake for the 2013 GS (Video Update)
04-17-12, 10:35 PM
#50
04-18-12, 09:04 AM
#52
Lexus Fanatic
Thread Starter
iTrader: (10)
Join Date: Nov 2004
Location: Under an IS F since 2008
Posts: 13,446
Received 1,058 Likes
on
586 Posts
AWD Prelimanary Update...
Originally Posted by k20eg
Really want to know if this will fit awd. Would buy before I even get my car haha
Well it's not looking good so far with all my prelimanary research...
The data shows 2 different part #'s are used for the Primary manifolds on the GS Application..
One for RWD and the other for AWD...
~ This is usually to make room for the front drive axle shaft, as seen on the current IS AWD & older GS AWD Models.
Also shows two different sets of the rear O2 sensors.. One for RWD & the other for AWD.
Still wating to confirm Mid-Pipe part numbers.. The axle-back section parts numbers are sort of irrlevant, but will confirm those as well..
~ Joe Z
Last edited by Joe Z; 04-18-12 at 12:02 PM.
04-18-12, 11:32 AM
#53
2013 GS350 AWD Update....
Well it's not looking good so far with all my prelimanary research...
The data shows 2 different part #'s are used for the Primary manifolds on the GS Application..
One for RWD and the other for AWD...
~ This is usually to make room for the front drive axle shaft, as seen on the current IS AWD & older GS AWD Models.
Also shows two different sets of the rear O2 sensors.. One for RWD & the other for AWD.
Still wating to confirm Mid-Pipe part numbers.. The axle-back parts numbers are sor of irrlevant, but will confimr those as well..
~ Joe Z
Well it's not looking good so far with all my prelimanary research...
The data shows 2 different part #'s are used for the Primary manifolds on the GS Application..
One for RWD and the other for AWD...
~ This is usually to make room for the front drive axle shaft, as seen on the current IS AWD & older GS AWD Models.
Also shows two different sets of the rear O2 sensors.. One for RWD & the other for AWD.
Still wating to confirm Mid-Pipe part numbers.. The axle-back parts numbers are sor of irrlevant, but will confimr those as well..
~ Joe Z
04-19-12, 09:32 PM
#55
Lexus Fanatic
Thread Starter
iTrader: (10)
Join Date: Nov 2004
Location: Under an IS F since 2008
Posts: 13,446
Received 1,058 Likes
on
586 Posts
That also has yet to be verified... ( like the AWD )
If it does, I am sure we can offer additional turn down attachments that simply connect to our mufflers.
~ Joe Z
04-19-12, 09:38 PM
#56
