Push start cranking but not starting
#1
Driver School Candidate
Thread Starter
I installed a Easyguard ec004 push-to-start system but I cannot get it to stay on. I bought the chip immobilizer and still not on. Do I have to wire the key illumination Ring and the key unlock warning switch? It’s a pretty basic easy to install system.
Last edited by BoriGS300; 02-18-20 at 07:22 PM.
#2
Does the aftermarket push start system come with instructions? I think you might have to find a way to bypass the old system. Bro, thats some dirty wiring lol. I hope you're not planning to tape that up when you're done.
The following users liked this post:
EuroWill (02-19-20)
#4
Will
Thread
Thread Starter
Forum
Replies
Last Post
Ravibah
Car Chat
4
08-14-22 05:33 AM
sutekidane
IS - 2nd Gen (2006-2013)
25
02-09-17 06:32 AM