How do you install the driveshaft?
#1
Advanced
Thread Starter
How do you install the driveshaft?
Put the motor in (GS400) a few weeks ago and was waiting for a new driveshaft to arrive. But now I'm a little frustrated trying to get it in.
Q: Do I need to move the motor? I removed the heat shield and can see the where the drive shaft goes but there doesnt seem to be enough room to maneuver. Any help would be appreciated.
Q: Do I need to move the motor? I removed the heat shield and can see the where the drive shaft goes but there doesnt seem to be enough room to maneuver. Any help would be appreciated.
#3
Advanced
Thread Starter
Thanks. Funny how things seem much simpler in the light of a new day. Yea, just popped the rubber donut off the shaft So it could clear the tranny mount. Then with one hand holding the driveshaft and the other pulling the "spline"? down a little, it slid right onto the rear spline. EzPeezy.
#4
Lexus Test Driver
iTrader: (8)
Thanks. Funny how things seem much simpler in the light of a new day. Yea, just popped the rubber donut off the shaft So it could clear the tranny mount. Then with one hand holding the driveshaft and the other pulling the "spline"? down a little, it slid right onto the rear spline. EzPeezy.
__________________
Thread
Thread Starter
Forum
Replies
Last Post
TLsc300
Performance & Maintenance
6
06-11-12 06:11 PM