Just put borla tips on. When I had them welded on I think they pulled them out a little. What do you think? I kinda wanted them to be flush with the exhaust opening.

 

Doesn't look that far too me... but then again this wasn't too far for me either...

 

What the H..? Now thats far.. your in NY right? How did you parallel park without doing damage to your exhaust??

 

 

LOL. Yea. It wasn't too hard. I just parked normally. lol

Oh and the tips were never connected to the exhaust. I wanted to see what they would look like first. I did drive around like that for a little while though,

 

they stick out but not that far imo

 

I get your point.. lol

 

car looks *****in man! And no they do not stick out, they look kinda OEM-ish...

 

Thanks bro..

 

looks good...I like the exhaust, lower the back to level off the car though

 

It works for me personally because the angle of the tips almost is comparable to where the bumper drops off. What are the specs/info on them?

 

OP:They appear just fine, far enough to avoid exhaust burns on the paint but not too far as to look ricey.

 

Thanks.. As far as the rear.. I know. Thinking about jumping on the UAS band wagon. Changing the rims and removing that spoiler are priority right now tho.

Borla Model #20155 2.5 4.25 x 3.5 oval

 

They don't stick out that far, but they look like they are a little low...? Are they supposed to fit in the cut outs?

 

They look a little too low to me... Maybe it's just me though. I had my Borla tips custom welded to how I wanted it so I don't know where they are supposed to be exactly. Check my sig for comparison.