Pumping guards
#1
Driver School Candidate
Thread Starter
Join Date: Nov 2013
Location: QLD, Australia
Posts: 37
Likes: 0
Received 0 Likes
on
0 Posts
Pumping guards
Hi all.
Would it be possible on a 2nd Gen GS to pump the rear guards 2cm and the front guards 1cm without needing to cut into the metal and damage the paint?
Cheers.
Would it be possible on a 2nd Gen GS to pump the rear guards 2cm and the front guards 1cm without needing to cut into the metal and damage the paint?
Cheers.
#2
Driver School Candidate
Join Date: Dec 2013
Location: Victoria, Australia
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
On both front and rear lips of a GS2 they retain a small square plastic clip which keeps a thin metal trim captive. If you're trying to push your guards out with a roller (after removing the clip) they will tend to buckle oddly and not be a super straight roll. Most guys cut the inner lip off or trim it significantly. I got mine rolled (no cutting) and I reckon they sit about 10mm further out than stock, but on close inspection, they definitely are not straight.
Thread
Thread Starter
Forum
Replies
Last Post
FUZCO
IS - 3rd Gen (2014-present)
3
10-15-17 12:09 PM
ArmyJoe
LX - 1st and 2nd Gen (1996-2007)
6
02-10-07 02:46 PM