1998 ES300 Master Key & ECU swap?
#16
Intermediate
If i may ask, how did you manage to make. The circuit speedkar made? I bought an eeprom programmer from ebay and and trying to figure out its setup. Can you give some details on your circuitry
#17
It was super simple. Just follow his schematic. Iw 5.1v zener diode x3. 4.7v resistor x3 a few little wires and a pamona clip on a little prototype board. I just cut a serial cable i had. I can post a picture in a few hours. I ended up buying hundreds of resistors and diodes because there is no more Radio Shack around here.
The following users liked this post:
wmj259 (06-30-18)
Thread
Thread Starter
Forum
Replies
Last Post
jehmin
Lexus Audio, Video, Security & Electronics
7
11-07-23 12:12 AM
Kadrian21
GS - 2nd Gen (1998-2005)
16
03-09-17 10:32 PM
63Galaxie
GS - 2nd Gen (1998-2005)
3
10-27-16 02:50 PM