Found a bad vacuum leak sucking air around the output shaft of the ACIS on the side of the intake plenum. I've been searching for some kind of replacement seal for this shaft with no luck. Anyone have insight on this mysterious part? Is there even a seal? Do I just have a worn out part?
LeX2K
Lexus Fanatic
close
Today
- Join DateSep 2010
- LocationAlberta
- Posts:26,024
-
iTrader Positive Feedback0
-
iTrader Feedback Score(0)
-
Likes:2,500
-
Liked:4,319 Times in 3,620 Posts
There are two seals:
17300-20020
17127-62030
The 2nd one is for the plate to plenum, 1st one is part of the ACIS assembly. If you have a leak where the shaft goes into the plate you'll have to replace the ACIS valve.
17300-20020
17127-62030
The 2nd one is for the plate to plenum, 1st one is part of the ACIS assembly. If you have a leak where the shaft goes into the plate you'll have to replace the ACIS valve.
Closer inspection, if wound up being the plate to plenum seal. I guess the leak was strong enough to suck the starting fluid spray around from the side. All is good, with that for now.