|
can anybody tell me what this noise is???
I have been trying to find out what this problem is for months. My front brake pads only last for a month if i'm lucky before they are grinding again. I have changed the front rotors, brakes, calipers and brake hoses and i'm still having the problem. it only happens at highway speeds and I recorded it while i was driving the link to the video is
|
Did you do the work yourself or at a shop?
|
Originally Posted by MrBooby
(Post 8673114)
Did you do the work yourself or at a shop?
|
a bulged tire? It's been a while but it seems like the very similar problem I had a long time ago with a bulged tire due to high air pressure.
|
Does the camry have a 'hanger bearing' on one of the cv shafts cos I'd bet it was that, or something else in the final drive line/ rotating assembly ?
- so, wheel bearing, - or rotor - or tyre - or half shaft (hanger) bearing (one side only). located at the back of the engine on a mounting plate with half shaft through it. |
The specific year and model of your Lexus might help narrow down the issue.
Do the brake pads wear out on both sides or just one? If the noise is from a tire or the half shaft (cv shaft), it wont effect the brake wear. A bad wheel bearing could be causing brake pad wear on one side only. |
You, my friend, have a serious problem there.
The vibration (if not an absolutely wrecked tired), is your half-axle. You'll get a vibration when you accelerate, and it lessens (a little) when you coast, right? The CV joint is probably dry, and the gears are rubbing. The only thing that indicates something else is your brake replacement frequency. I would look to see if you've got a seized caliper. You'd notice the car would pull if that was the case, but you never know. Post a picture of your front tires (I want to see the treads) to see what alignment bits are off. Honestly, I would take it to a local suspension guy you trust and have him drive it and throw it on the rack. Diagnosing it here is difficult. And if I'm right, and it is your CV joint, you're going to brake that half-axle and be stranded. Good luck! Keep us posted on what you discover at the shop! |
thank you everybody for replying and sorry for taking so long to respond back....one of my best friends of almost 15 years passed away so i been dealing with a lot
|
Originally Posted by Nelexus88
(Post 8674027)
The specific year and model of your Lexus might help narrow down the issue.
Do the brake pads wear out on both sides or just one? If the noise is from a tire or the half shaft (cv shaft), it wont effect the brake wear. A bad wheel bearing could be causing brake pad wear on one side only. |
Originally Posted by SharpGent
(Post 8678888)
You, my friend, have a serious problem there.
The vibration (if not an absolutely wrecked tired), is your half-axle. You'll get a vibration when you accelerate, and it lessens (a little) when you coast, right? The CV joint is probably dry, and the gears are rubbing. The only thing that indicates something else is your brake replacement frequency. I would look to see if you've got a seized caliper. You'd notice the car would pull if that was the case, but you never know. Post a picture of your front tires (I want to see the treads) to see what alignment bits are off. Honestly, I would take it to a local suspension guy you trust and have him drive it and throw it on the rack. Diagnosing it here is difficult. And if I'm right, and it is your CV joint, you're going to brake that half-axle and be stranded. Good luck! Keep us posted on what you discover at the shop! https://cimg4.ibsrv.net/gimg/www.clu...bf633f79b0.jpg https://cimg5.ibsrv.net/gimg/www.clu...7707916287.jpg |
This is definitely not a tire issue. I don't get why people keep saying it's a a tire issue (everywhere online) when clearly his brakes are wearing down fast.
I would check your braking system again. Brakes wearing down at an exponential pace means that it is always engaging at some amount (not releasing fully). This is highly due to stuck calipers or sliders. Check these first! Make sure your DOT3 brake lines do not have bubbles inside them. Bleed them. Do your rotors heat up after driving for at least 30 mins? How do the brake pedals feel? Do they have any pressure pushing back like normal? How far do you have to push down until the brakes engage? At a stop when you push down on the brakes, do the brake pedals sink in after a while? |
Either way I would recommend to go to a different shop so that they can test everything.
Just make sure to explain your issue in great detail so that they don't just replace your brakes again. |
Originally Posted by hanime
(Post 8689475)
This is definitely not a tire issue. I don't get why people keep saying it's a a tire issue (everywhere online) when clearly his brakes are wearing down fast.
I would check your braking system again. Brakes wearing down at an exponential pace means that it is always engaging at some amount (not releasing fully). This is highly due to stuck calipers or sliders. Check these first! Make sure your DOT3 brake lines do not have bubbles inside them. Bleed them. Do your rotors heat up after driving for at least 30 mins? How do the brake pedals feel? Do they have any pressure pushing back like normal? How far do you have to push down until the brakes engage? At a stop when you push down on the brakes, do the brake pedals sink in after a while? |
Originally Posted by MrBooby
(Post 8689713)
Either way I would recommend to go to a different shop so that they can test everything.
Just make sure to explain your issue in great detail so that they don't just replace your brakes again. |
actually, that's in the rotating mass so, tyres are definitely an option, so are wheel bearings, and brakes.
|
| All times are GMT -7. The time now is 10:34 AM. |
© 2024 MH Sub I, LLC dba Internet Brands