lexwill

1999 es300.. recently just put leds all thoughout interior except vanity mirrors. Then my his are in the mail so will put those in asap and the my leds for liscense plate also is in the mail. Did a thourough interior clean and wash on outside. Debadged her with some floss and waxed out. Amazing. And a whole lot more to come :-)

johnblagg

today I did every vacuum line.... yesterday it was plugs wires and distributor cap ect

johnblagg

whoo hoo leak fixed new oring in and good for a few years ....not nearly as hard as it looks either,not the easiest but not that bad you need a deep well 12mm and a 12 mm box end to do the job and there are four bolts one just above the oil filter itself

johndeez

just finished detailing the hell out of it and did a complete tune up, all fluids , and new brakes and tires ././....mission acomplished ..yay

flyfl1pguy

iTrader: (2)

Did a little tune up. New spark plugs and an oil change

marcoes300

i did buy some 6000k HID for nigth beam, ill probably instal them tomorrow. bought new battery and wiper blade

flyfl1pguy

iTrader: (2)

post pics once install is complete

Yurka

changed my windshield wiper blades, vacuumed it and washed all the windows

es30000000

Yesterday I installed a hardwired auxiliary input in my car and replaced the front strut mounts and sway bar end links in my dads 97es

imherenow

changed power steering and brake fluid by sucking out what ever i could and repeating it few times. and washed the car. Also cleaned the IACV. And it was super foggy so took my some shots

imherenow

today i cleaned used Mothers sealant & glaze followed by Mothers carnauba wax. Then i cleaned MAF sensor. Now we wait and see if the i get some increase mpg

01LEXPL

iTrader: (10)

Please fix your lights... The reflector is designed for a specific fiction, look how dim those outer's are compared to the inner lights - which supposed to be the dimmer ones out of the two. And why are the fogs so amber looking? What did you do to them?

imherenow

hehe yes yes i will eventually. i changed the bulbs for the inner ones recently but the ones that are dimmer i noticed that the bulbs are jet black . like they are not clear , so maybe thats why they look dimmer However none of them are blown out yet.
About the yellow fog light its because i sprayed them with yellow especially made for glass surfaces. had it for long time now. it was pain in *** to do it in that tight spot. it would have been easier to work with if i knew how to remove the fog light assembly. But meh its looks good . plus i have slightly changed the angle of light.

DanES300

Where did you get those needles?

pacheco308

so far i changed the driver side axle which sucked distributor cap and rotor oil change spark plugs new ac belt ordered lh rear taillight off eBay searching for a power steering pump now