glenda2614

I have a 1994 ES300 that I recently change the ti-rods on, since then whenever I start the car and put in drive it does not move, I have to wait 10-20 minutes before it engages then I can move. Any suggestions as to what the problem is?

mmlex1987

Changing the tie rods has no correlation to the problem you are experiencing other then possibly you knocked something loose. I would look very closely in the areas you were working in.

llcoolpass

this thread is so misnamed its not even funny.

first, properly check the transmission fluid level and condition. there's a procedure for that [not the same as motor oil].

if low, add, and find source of leak and repair.

if not low, you may have to go to 2 or more transmission specialists to get an estimate.