SC400onDubz

I need some help.

I have no power on the radio. I need to know what color are the main power (memory) and the keyed power(ign1) wires or also where they are located on the harness that goes into the reciever..

Any help would be great..

Thanks,
Scott

CPerez100

Scott:
I hope that someone else replies to this thread. In the mean time just in case you have everything out, I can tell you that on my experience on Toyotas the Power is the red wire. The Accessory power is the yellow (power ignition).
Black of course is the ground.

I hope this little hint helps..

Carlos

Fudd508

I actually labeled my wires when I installed my radio….i have everything but the speakers I can tell you everything you know when I get a moment to remove my stereo to install new speakers

SC400onDubz

Yeah...

Let me know as soon as you get a chance. No radio sucks..

Someone evidently put in an aftermarket and cut the wires and then tried to patch them up... But there is only one source of power with the key on. and no power with the key off.. A real hack job..

I hope after the power is on that the speakers work..


BTW, I only need the power, keyed, and ground wire colors or places on the connector.

Thanks,
Scott
wscottwilliams@home.com

alvin

gray pin 3 is ACC

pink\blue pin 1 is amp+

white pin 11 is ground

brown pin 5 is mute

green red pin 8 is ant+

this is from clip A to the deck

clip B goes to the CD changer

Alvin
Green ES 300

92lex

I guess I was too slow but here it is any way.

92lex

speaker wires found under pass. seat.
amp under passenger seat

SC400onDubz

Thank you very much...

Very good work of diagraming. Thanks again for all of the time you must have spent..

Scott

CPerez100

Thanks 92Lex... nice explanation.. went all the way into the detail section..

zerwick

Since there are 6 pairs of speaker wires coming from the stock amp, how do you hook them up to the aftermarket head unit? Should you hook 2 pairs together?

92lex

I ended up combinding the front dash and doors together. I know that this will change the ohm load on the stereo, but hat the hey.... it still sounds good to me

Balzak

can you tell me exactly how you managed to hook up your tweeters? b/c right now all i can get sound out of is the two front main speakers.

92lex

the door tweeters run off the door speakers. That was how they where done from the factory. Hope this helps

in_famous

does anyone know which wire would be the remote wire from the factory es300 amp? thanks.

92lex

Why do you need a remote off the factory amp? Use the antenna wire off the deck, or off the real antenna in the trunk. I labeled the speakers on the amp s the are only 4 wires left, jjust check them with a volt meter. I replaced the whole sound system or I would check for you.