LXMN

I just finished one side of my headlights for my retrofit project. It is my first time doing this so critique lightly please. Here are some pics...

LXMN

Here is the second pic

LXMN

Nice reflection shot off of the side of the housing

LXMN

Crisp white light shining through the projector. Using Phillips D2S 85122+ for the bulb.

LXMN

Plastic lens cover back on and sealed up. The headlamp in the background is up next. Just removed the cover earlier today.

LXMN

Another pic of the lens cover on the headlight.

LXMN

Almost wish I had covered up the high beam with a projector lens on this shot

LXMN

The back of the headlamp with the stock rubber cover for the low beam light with an aftermarket wire harness attached to the bulb. Very tight seal around the harness. Should provide good moisture protection.

LXMN

Wall shot with a nice crisp cutoff line.

chrispy

iTrader: (21)

wow that's great! i did a projector retrofit two weeks ago and i don't have pictures yet. looks very well done compared to mine. i used e46 bixenon projectors so they were harder to make fit than the tsx ones. it was also hard to make room for the bixenon shield. can't wait to see them on your car.

charley240

iTrader: (6)

looks great, post pics when youre done. currently i have the factory hid setup, but have been debating on going to retrofit with my factory non hid headlights for better lighting.
Charley

Maxx941

iTrader: (1)

Nice Job!
I can't wait to see them installed

tuan92129

Looks nice

Limen

Damn, that really would set the car off. Looks great!!!

tmf2004

iTrader: (15)

Wow that came out great.. Nice job...