Rear Camber Adjustment??
#1
Driver School Candidate
Thread Starter
Join Date: Jul 2012
Location: Houston, TX
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Rear Camber Adjustment??
Hi, I recentedly dropped my CT and I was wondering if anyone had any idea on how to adjust the rear camber? My driver side rear is -3.6 and my passenger rear is -2.3. I want to get wheels but I need my camber to be able to adjust before picking up a set of wheels.
Anyone with a dropped CT can help??
Anyone with a dropped CT can help??
#3
Anyway, from the manual:
"Camber is not adjustable. If the measurement is not within the specified range, inspect the suspension parts for damage and/or wear, and replace them if necessary."
This refers to the rear only. For the front check my other thread.
It also says;
Camber (Unloaded Vehicle):
-1.00 deg. +/- .75 deg
So technically a -1.75 camber angle on a stock vehicle is acceptable.
"Camber is not adjustable. If the measurement is not within the specified range, inspect the suspension parts for damage and/or wear, and replace them if necessary."
This refers to the rear only. For the front check my other thread.
It also says;
Camber (Unloaded Vehicle):
-1.00 deg. +/- .75 deg
So technically a -1.75 camber angle on a stock vehicle is acceptable.
Last edited by m R g S r; 02-25-13 at 07:55 PM.
#4
Driver School Candidate
Thread Starter
Join Date: Jul 2012
Location: Houston, TX
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post