Originally Posted by oldwineguy

Finally ready to roll...

Originally Posted by GetUrWheel

Looking good guys!

AG just released their M540s in 5x100 18x8 +30 and 18x9 +30!

(Shown in standard Machined Silver finishing)

I'd love to see a set on a CT200H!

Originally Posted by oldwineguy

Originally Posted by Miamiboy87

Are those F1r F29s??

Originally Posted by MNT250

Used grey metallic plastidip on the chrome, relocated the license plate - pre spacer install


spacers 25mm rear 20mm front


mirror relocation bracket


now the mirror isn't blocking half my view


did some other mods too, 5000k HID in headlights, LEDs in all the interior lights. Thinking that's it for awhile!

Originally Posted by genji

found these pics online. these are super clean. i wonder what offset /setup

Originally Posted by oldwineguy

Those are Rotiform CCV, they have 5x100 in 18x8.5 +35 and 18x9.5 +25, but they are heavy

Originally Posted by oldwineguy

Sold my CT today, you should be seeing her in NorCal now.

Originally Posted by lilboi

That's sad. You have one of the cleanest CTs on the board.
What did you move on to?

Originally Posted by SteveMason

Not necessarily...
If I build one, it will be similar to this one:

http://www.ct200hforum.com/forum/lex...d-stealth.html


See, we are lucky because we have that useless foam piece over the spare tire that is just designed to raise the rear trunk height to match the battery pack height. I think we could actually use those hollow spaces to our advantage and have a sub on each side, and use the hollow space as a resonance chamber. Then you could drill a hole about 1.5"-2" in diameter in the carpet of the removable side panels, and a ton of base would blast out! You could probably find a chrome ring of the same diameter to make it look pro!

that is why, unlike the design above, I would put the amp in the middle, and have two 10" subs at an angle on each side. Then the resonance chambers I mentioned would work better. Then to top it all off, I would put a plexiglass window on the top at trunk height, line the wooden housing with carbon fiber vinyl, and add some blue LED's to illuminate the amp and subs... I think it would look amazing!

(Just make sure you add length to all the wires so you can remove the entire unit to get the spare tire and jack out... Ideally it could be designed with hinges or a lift mechanism but I think that is just getting too complicated!)

I feel like the moderator should think about making these posts about the sub another topic because I was just thinking it's OT.

Originally Posted by oldwineguy

Sold my CT today, you should be seeing her in NorCal now.