AeroTect

Is now available...

http://aerotect.net/catalog/index.ph...c5616e021c6b8c

Adi did a great job designing this one. A little trimming is necessary to make sure everything wraps nice, but we are including the razor knife for the application.

You will need to remove your door trim and console pieces, and I think there is a thread somewhere on CL that shows how to do this. We should also have an instructional video available online by next week.

Order by the 16th to qualify for our holiday gift drawing.

PaPaHoFF

iTrader: (19)

No glue is required for this right?

Does it wrap around the edges and the weave will come in all the same direction correct? I noticed the ash tray in the pics goes the opposite way.

isthrizzy

I have done this myself...it looks much better if the weave is aligned between the ash tray door and the console.... as shown it is in opposite directions.

Robs IS250

iTrader: (4)

I would order this right now but too bad you dont have anything for the 6 MT!

AeroTect

No glue or primer is required for this application.

It does wrap around the edges. The only exposed part will be on the inside corners of the Cup holder cover, and that will be visible only when open.

The weave will be going in the same direction... see the pic of the final kit below.

isthrizzy, the weave will all be going the same direction. See the pic of the final kit below.

Well, if your close by, come on in and we'll see what we can do. Otherwise, We'll see what we can do on the next 6mt that comes in.

Pic of the final kit

file82

how can i remove it if i want to change to different style?

AeroTect

The adhesive is fairly aggressive, but it will peel off like a tough sticker. Using a little heat gun to soften the material may help... If you even need it.

bayron

do u have the set for is300?? i would like 2 order the set lmk

AeroTect

Nothing yet for the IS 300, but if you come by, we can see what we can come up with.

MotoX

iTrader: (2)

Just ordered a set. Thank!

bayron

where r u guys located @

omgswifty

iTrader: (5)

any middle console cf pieces for the NON-heated seat IS? Only diff is that the NON-heated won't have the space for the heated seat option at the top. pls lmk!!

DRivera250

iTrader: (6)

do you have one without the seat warmers?

AeroTect

La Verne, CA... check our website for the address. www.aerotect.net

When checking out, just add in the comment box: "attn: Jason, please remove seat warmer control cut-out"
The order will be directed to me, and I will make sure to remove the cut-out from the kit.

Look up.

k4fu

iTrader: (5)

hey aerotect, can't you somehow improve the cutting on the corners so that the gap would be minimized?