man i think my endlinks are done :(
02-22-10, 01:07 AM
#1
Pole Position
Thread Starter
Join Date: Nov 2005
Location: hawaii
Posts: 336
Likes: 0
Received 0 Likes
on
0 Posts
man i think my endlinks are done :(
so i had my brakes changed out last month and since then i've been hearing all kinds of noise coming from my suspension when i go over uneven roads. basically its alot of clunking, clanking, rattling banging type of noises that are rather annoying. now the car still rides fine other then the annoying noise and when i'm on even flat roads there is no noise at all. i'm hoping theres no additional damage from driving the car in this state.
so, after reading here and on my.is i gather either my endlinks are dead or my bushings need to be changed? any ideas ppl? does this sound about right?
so, after reading here and on my.is i gather either my endlinks are dead or my bushings need to be changed? any ideas ppl? does this sound about right?
might be the bushings need to be changed. i know on the myis a few of them had the same problem.
03-23-10, 09:20 PM
#5
Getting the same rattling noise on my car as well. Sounds like my right side rear. Guess I'll go visit chad at LXS again and have it checked out unless us 1st gen IS owners can have a "garage day". 
03-23-10, 11:55 PM
#7
Pole Position
Thread Starter
Join Date: Nov 2005
Location: hawaii
Posts: 336
Likes: 0
Received 0 Likes
on
0 Posts
i can be labor 
but yea, i still have yet to get this addressed... hopefully the noise isn't causing any additional damage.
Trending Topics
03-24-10, 07:17 PM
#11
03-25-10, 02:36 PM
#14
Pole Position
Thread Starter
Join Date: Nov 2005
Location: hawaii
Posts: 336
Likes: 0
Received 0 Likes
on
0 Posts
that would be fine, except being as i was never that good at troubleshooting mechanical stuffs i'm not exactly sure if the endlinks are done or the bushings are. but, considering what i do know... i'd say endlinks 
that being said we'd have to order the parts somewhere... perhaps, carson toyota?
and assuming the endlinks are just remove & replace should be no problem.
except gotta make sure someone has a floor jack with stands, etc. obviously some wrenches, etc would be nice.
oh and i got about 92.xxx on my car.
that being said we'd have to order the parts somewhere... perhaps, carson toyota?
and assuming the endlinks are just remove & replace should be no problem.
except gotta make sure someone has a floor jack with stands, etc. obviously some wrenches, etc would be nice.
oh and i got about 92.xxx on my car.
03-25-10, 02:47 PM
#15
Pole Position
Join Date: Feb 2009
Location: HI
Posts: 322
Likes: 0
Received 0 Likes
on
0 Posts
i got the stands (4) but no floor jack..... if ur slammed then we might need to ask kurt if we can use his jack. im good to go i=on sat but sundays is a no go. got soccer to play. but food n 1is days sounds good. Frred!!! how u been man! long time no see. hows the gs doing? and the 1is?