1997 SC300 Project
05-28-17, 08:36 PM
#61
I used to really like BRZ's until a few years back I was doing some racing against a buddy of mine in our car club in my stock 1995 SC400 versus his stock BRZ and we were dead even. I thought for sure his lighter BRZ would edge out the boat of a stock SC400, but apparently not. Great build!
Ya, the BRZ is a fun car, the steering is pretty good. I would say (steeringwise) the SC is on par if all the bushings are replaced. Its the high ratio rack that makes it feel less sporty. 17.5 to 1. Newer cars have much lower ratio so it feels sportier.
I actually love my SC's steering more than my ISF.
05-30-17, 06:49 PM
#62
I wired in the flex signal and the mac valve. More updates when I get my pfte lines from racetronix.
Going to mount the flex sensor and filter in the trunk.
06-13-17, 09:18 PM
#63
06-23-17, 07:18 AM
#64
Got the fuel system done. I went with a -8an bulkhead fitting. It was a pain to get it to fit on the vent cover.
I've been doing some street tuning. Setting up up the fuel is pretty easy on the Infinity. Not messing with the timing until I can get it on a dyno.
Ive encountered some weird issue. The speedo is now wavering. It did not have that issue before.
Car overheated to 220F in 110F weather. I dont think this is the fan because I am getting that temp on the freeway. I don't think I have enough room to go back to the clutch fan. Maybe bad water pump? The car holds temp at idle and I already bleed the system.
The following users liked this post:
aswang (07-11-17)
07-31-17, 06:47 PM
#69
This is on the stock cat back with a 60mm turbo on e85.
Was amazed the engine I amateurly built held up.
