PaCowboy

iTrader: (6)

That's cool. I'm sure your build will be bad ***!! Esp with the TS supra as your inspiration!

Funnyman

Thanks man I'm still at least a year out on getting my car to that point first is cosmetics and interior then driveline. Engine build trans swap subframe swap turbo ect ect

PaCowboy

iTrader: (6)

What motor u using?

Funnyman

Just the stock ge with TT cams unless I can find a deal on aftermarket ones im going to be researching what to use this summer as of now just going to refresh the bottom end tt headgasket arp studs probably tt injectors and rail already have super spark coils then I don't know which manifold but some ffim to run the v mount

Funnyman

Along with a precision v2 62/62 custom manifold either tial or precision WG and a tial bov custom bell intercooler .. I still have a lot of reading and research to do before its done but I got a good chunk of parts for it now

PaCowboy

iTrader: (6)

Nice sounds like it's gonna be a nice setup. If ya need any help let me know. I'm getting my 264 cams, intake manifold, 90 mm tb, and tt auto rear put in end in the next week or so. Building my own 4 inch dp,mp and dual 3 inch exhaust. Then back to the Dyno. In hopes we can get a 700 plus pull on 116

Funnyman

Damn that's impressive im only shooting for 5-550 wheel but thanks I'll keep you in mind when I start buying parts im going to subscribe to this build

PaCowboy

iTrader: (6)

Thanks. The end result of the build hopefully will be a 4 digit Dyno pull and a low 9 street car. We will see how it goes. There's always curve *****

Funnyman

Always I just finished building a 2010 335xi with 608awhp and now it's got phantom coolant leaks those cars wernt ment to make that power on factory frame turbos and now we're finding out the hard way lol I have to inspect again tomorrow this will be the 4th time it's gone on the lift for leaks
1000+ is too much for me I've built and driven a gtr with close to that and it was scary fast good luck tho that's really exciting

PaCowboy

iTrader: (6)

My 4 inch downpipe/midpipe to dual 3 inch str8 pipes to magna flow muffler setup is complete. Thanks to supra dr. And finally got my two step setup done on my aem. Just need to figure out how to post the small vid of the two step.