When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Couple new parts ordered before the end of 2016. I believe these are 'firsts' for our chassis, so I'll have some feedback after all parts installed.
KAZ-SUS Reinforced Stabilizer Bar (Front Sway) - Since I have all the Tom's Racing Braces and Front Strut, I've been following the development of this KAZ-SUS bar since they've been in collaboration with the Mode Parfume demo cars. Picking this piece up essentially completes the set of all support "bars" available. Girth comparison in the bottom pic.
Secondly, after a fairly convincing conversation with a friend, I was convinced that it was time to install an aftermarket exhaust since I have been "leaving power on the table". Since the drone from the Joe Z mufflers was too much for me, I was convinced I didn't want to install an exhaust on this car unless it was a Suruga Speed. To my surprise, I found a slightly used one available for a steal of a price, so now I'll be waiting on the delivery of a Suruga PFS Loop Exhaust.
I'm also looking in exhaust but afraid of the in-cabin drone. The clip sounds legit!
Since having an exhaust previously, I know for certain the drone between 2-4K was maddening to me. Here's a clip of the in-cabin sound of the Suruga exhaust (+Tom's Supercharger). Hopefully it's what I've been looking for. https://www.youtube.com/watch?v=aHjvhtcfJS4&t=119s
Since having an exhaust previously, I know for certain the drone between 2-4K was maddening to me. Here's a clip of the in-cabin sound of the Suruga exhaust (+Tom's Supercharger). Hopefully it's what I've been looking for. https://www.youtube.com/watch?v=aHjvhtcfJS4&t=119s
Wow even with the s/c it doesn't sound bad at all inside!
I'm curious about the design. I see it's a loop but only 1 visible canister instead of some loops have 2 canisters and 2 ubends... or am I missing something here? Looks like it's just a longer pipe doing a loop.
Looking to get the loop from Aimgain later but for now I ended up ordering 2 borla's and custom my axle back first until then. Deciding if I need to loop it or buy 2 more borlas on each side to reduce any drone.
Kaz-Sus sway bar has been holding up well. I got them imported from Japan through Jin at Kyoei-USA. The chassis is noticeably stiffer as a result. I would suggest reaching out to Jin at Kyoei USA or Freddie at AutoFashion USA if you want to order it.
12-12-16, 04:24 PM
Visual Motivation for sure!
