Sc300 W58 to cd001, HELP!!!!

Reply Subscribe

Thread Tools

Search this Thread

Nov 17, 2023 | 08:08 PM

alphakill8

Thread Starter

6th Gear

Joined: Oct 2023

Posts: 6

Likes: 1

From: Florida

Sc300 W58 to cd001, HELP!!!!

Hello I have a 1996 sc300 factory manual with a W58 in it I recently picked up a cd001 and plan on attaching the sequential shifter to it. I was wondering can I just use an adapter kit to fit the cd001 to the 2j and do I need to get a new slave cylinder? I know I need a cd001 clutch but for the slave do i need to do anything or can I just use the one I already have in my car? Also do I need a new drive shaft?
Also are there any adapter kits you guys recommend? and can I use the bell housing from my W58?

Last edited by alphakill8; Nov 17, 2023 at 09:01 PM.

Nov 21, 2023 | 08:52 PM

Rcreegan

Intermediate

iTrader: (2)

Joined: Feb 2015

Posts: 307

Likes: 162

From: Va

See my responses in bold

Quote:

Originally Posted by alphakill8

Hello I have a 1996 sc300 factory manual with a W58 in it I recently picked up a cd001 and plan on attaching the sequential shifter to it. I was wondering can I just use an adapter kit to fit the cd001 to the 2j and do I need to get a new slave cylinder?
the slave many of these kits is a t56 I believe. You may need a new master cylinder depending on the clutch you go with .I know I need a cd001 clutch but for the slave do i need to do anything or can I just use the one I already have in my car? Slave does not move over, I think you’re calling the master cylinder the slave. The master attaches to the clutch pedal and the firewall, Slavs sits on the transmission. Also do I need a new drive shaft? Yes
Also are there any adapter kits you guys recommend? I would recommend the serial nine kit or the fisch racing. and can I use the bell housing from my W58? No , will not work

hope that helps you.