NM IS-F Downforce USA front lip
12-10-11, 08:07 AM
#1
IS-F Downforce USA front lip
I've finally decided to sell this piece. I purchased it from ViperVern when he parted out his ISF and have moved on to something different so I don't need two front lips.
There is a small defect to the clear coat that created small spider cracks in the clear coat. It is not noticeable from a distance more that a couple of feet but if your right in front of it and know what to look for you'll be able to see it. This is the way I bought the lip and did not have any desire to fix it since it is barely noticeable. I've tried to take a couple of pics close up so you could see.
Other than that, this lip is very nice and pure carbon fiber with clear coat, no fiberglass backing on this. You will have to drill small holes in the bottom of the stock bumper to install and the screws I used are included. No double sided tape needed.
I've included pictures when the lip was mounted as well for an idea and you can also visit the Downforce USA website for more pics of ViperVern's car when he had it installed.
Asking $525 shipped to lower 48 states. If your lucky enough to be local I'll drop the price a little.
I have a little feedback on here from transactions and carry the same handle on Ebay for many years if you'd like to see my history.
Also, this lip is very friendly to lowered cars, it projects out more than down. I run TEIN CST and have a slightly inclined driveway the clearance is affected by less than an inch downward from OEM and I never had issues anywhere with this piece.
Thanks for looking.
There is a small defect to the clear coat that created small spider cracks in the clear coat. It is not noticeable from a distance more that a couple of feet but if your right in front of it and know what to look for you'll be able to see it. This is the way I bought the lip and did not have any desire to fix it since it is barely noticeable. I've tried to take a couple of pics close up so you could see.
Other than that, this lip is very nice and pure carbon fiber with clear coat, no fiberglass backing on this. You will have to drill small holes in the bottom of the stock bumper to install and the screws I used are included. No double sided tape needed.
I've included pictures when the lip was mounted as well for an idea and you can also visit the Downforce USA website for more pics of ViperVern's car when he had it installed.
Asking $525 shipped to lower 48 states. If your lucky enough to be local I'll drop the price a little.
I have a little feedback on here from transactions and carry the same handle on Ebay for many years if you'd like to see my history.
Also, this lip is very friendly to lowered cars, it projects out more than down. I run TEIN CST and have a slightly inclined driveway the clearance is affected by less than an inch downward from OEM and I never had issues anywhere with this piece.
Thanks for looking.
Last edited by clifftrail; 01-15-12 at 05:43 AM.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
projectdna
2Gen IS250 / IS350 / IS-F Classifieds (06-13)
10
06-25-18 12:34 PM
TISF
2Gen IS250 / IS350 / IS-F Classifieds (06-13)
0
06-02-15 06:51 PM
RX7 RAGE
2Gen IS250 / IS350 / IS-F Classifieds (06-13)
15
10-27-12 02:58 PM
RX7 RAGE
IS F (2008-2014)
4
05-13-12 10:45 AM
ISFJames
2Gen IS250 / IS350 / IS-F Classifieds (06-13)
7
04-05-12 09:26 PM
