FS: GTE cams machined to fit GE VVTi head
#1
Driver
Thread Starter
iTrader: (4)
Join Date: Mar 2008
Location: Illinois
Posts: 178
Likes: 0
Received 0 Likes
on
0 Posts
FS: GTE cams machined to fit GE VVTi head
USDM 2jzGTE cams Machined to fit 2jzGE vvti
Sold!!!!!!!!!
Still on the head, and accumulated rust from sitting in the garage. Just need a little Braso to clean it off.
In terms of performance.
USDM GTE cams specs:
Intake: 233 deg
Lift: 8.25mm
Exhaust: 233 deg
Lift 8.4mm
Exhaust apparently has 1.17mm more left than GE vvti cams.
http://my.is/forums/4015130-post46.html
Stock GTE cams are good for around 650-700rwhp!
Here is a website with the specification
http://mkiv.supras.org.nz/specs.htm
Pitures on the head BEFORE clean-up
Pictures Uninstalled cleaned up
Sold!!!!!!!!!
Still on the head, and accumulated rust from sitting in the garage. Just need a little Braso to clean it off.
In terms of performance.
USDM GTE cams specs:
Intake: 233 deg
Lift: 8.25mm
Exhaust: 233 deg
Lift 8.4mm
Exhaust apparently has 1.17mm more left than GE vvti cams.
http://my.is/forums/4015130-post46.html
Stock GTE cams are good for around 650-700rwhp!
Here is a website with the specification
http://mkiv.supras.org.nz/specs.htm
Pitures on the head BEFORE clean-up
Pictures Uninstalled cleaned up
Last edited by jroring; 06-02-09 at 06:02 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Bigzavs
1Gen IS300 Classifieds (98-05)
2
10-31-11 04:10 PM
YeA 2jZ
Performance & Maintenance
34
01-07-10 02:55 PM