hks hiper
#1
hks hiper
i have 2 hks hiper cans
they are in mint condition always polished and cleaned no salt or snow here in south florida .. i had them on my gs 400 then had it reconfigured to fit my sc300
i am about to order another set of hks pans because my car is turboed and i run 3in piping from my downpipe back and the hks pans that are used in in non force inducted are 2.25 in inlet
for your sc 400 and sc 300 you need the 2.25 inlet do not do 3inch you will lose the needed backpressure and your car will feel sluggish and slow i need to release back pressure to help expel gases to spool turbo and flow better
the hks sounds mean as hell esp and the v8 motor .. theirs no drone and i currently have no cats and no resonaters period .. on my gs 400 i had cats and res and was the sweetest sound
i know the pans cost around 250 a piece new if you want to save yourself some dough i would give them to you for 300 for both which is a savings to u of over 200
any muffler shop for a couple of box can chop off my flanges that were welded on to fit sc 300/4 and put back the gs flange
new these are 600+ why not save big
heres a pic
they are in mint condition always polished and cleaned no salt or snow here in south florida .. i had them on my gs 400 then had it reconfigured to fit my sc300
i am about to order another set of hks pans because my car is turboed and i run 3in piping from my downpipe back and the hks pans that are used in in non force inducted are 2.25 in inlet
for your sc 400 and sc 300 you need the 2.25 inlet do not do 3inch you will lose the needed backpressure and your car will feel sluggish and slow i need to release back pressure to help expel gases to spool turbo and flow better
the hks sounds mean as hell esp and the v8 motor .. theirs no drone and i currently have no cats and no resonaters period .. on my gs 400 i had cats and res and was the sweetest sound
i know the pans cost around 250 a piece new if you want to save yourself some dough i would give them to you for 300 for both which is a savings to u of over 200
any muffler shop for a couple of box can chop off my flanges that were welded on to fit sc 300/4 and put back the gs flange
new these are 600+ why not save big
heres a pic
Thread
Thread Starter
Forum
Replies
Last Post