HI SSR Agle Dish, Faces only
03-05-13, 06:16 PM
#1
Lead Lap
Thread Starter
iTrader: (13)
Join Date: Jan 2008
Location: 808 State
Posts: 508
Likes: 0
Received 0 Likes
on
0 Posts
SSR Agle Dish, Faces only
I bought these with the intention of rebarelling them, but I've got too many projects going on at once and could use the extra cash for other things. In any case, selling a set of 19" SSR Agle Dish, polished faces, center caps (missing 1 screw for 1 of the center caps, but that should be able to be purchased from any hardware store), and all mounting bolts and nuts. I think the previous owner mentioned they used to be white, but they were sanded and polished out. There are a few small areas of paint that still remains and knicks and stuff, but they should all be able to be sanded and polished to look like new again.....I just don't have the time. The original wheels were 19x8 +37, Lo Disk, and they should drop into a 40 hole barrels. Looking to get $500 plus the actual shipping cost and paypal fees. I just sent a set of faces to the mainland and it was about $150, FYI. Here's some pics:
Mods, not sure if I've been around long enough or have good enough trader rating, or if this is considered a high dollar sale for that matter, but I can get a vouch if need be. Just let me know. Thanks -Brandon
Mods, not sure if I've been around long enough or have good enough trader rating, or if this is considered a high dollar sale for that matter, but I can get a vouch if need be. Just let me know. Thanks -Brandon
Trending Topics
06-18-13, 10:54 PM
#9
Lead Lap
Thread Starter
iTrader: (13)
Join Date: Jan 2008
Location: 808 State
Posts: 508
Likes: 0
Received 0 Likes
on
0 Posts
PM'd you
Sorry, when you say "pics of these said and done", do you mean assembled? If so, sorry I don't. I had plans to rebarrel these to some really nice sizes, but I've got just too many projects going on at once. Somebody will score when they get to build these to their own desired specs.
Sorry, when you say "pics of these said and done", do you mean assembled? If so, sorry I don't. I had plans to rebarrel these to some really nice sizes, but I've got just too many projects going on at once. Somebody will score when they get to build these to their own desired specs.
Thread
Thread Starter
Forum
Replies
Last Post