aggiez28

2007 GS350 with ~160k miles

The rear brakes were making noises and when i took a quick look at the pads they looked to have plenty of meat on them (the outside ones which were visible at least)

I took off the wheels and took the pads out and the inboard pads on both rears were at ~1% while the outside pads on both were at ~70% material left. They were both like this which seemed a bit odd.

I had an extra set of pads and rotors so i put them on and when i went to test drive the car i could tell that the brakes were not disengaging. I could feel it and smell it. I took them off and swapped the inboard with outboard to see if that made a difference and it did not.

I could try new calipers but I dont think that is it as both calipers going out at the same time just dosnt seem right.

any ideas? master cyl? p. valve?

bmore430

buy new guide pins and re-grease.