//935GS400

Im thinking of getting this SSR Vienna rims. The size is 18x9 +19 with 3¼” of lip and Rears are 18x9 +3 with 4¼” of lip. Do you guys think this will fit on the aristo with no modifications to the fender and camber. I also have a tein springs. thanks!

GATO

iTrader: (1)

this probably belongs in the wheel section.

you threw me off with screen name.......but I see you do have a 2nd gen.

the answer is NO. it will not fit without modifications.

on the other hand, if you decide to do minor mods, those things will look awesome!

that front is nice an aggressive. you will be exactly flush. you wanna run a 225 on that 9 up front(and roll fenders). some Gs's out there running aggressive fitments on front are running 9 widths and offsets in the +20 to +24

that rear offset is crazy aggrressive, but your only on a 9......and that GS has known to take a 10,10.5,11 in widths. again, only if your up to minor modifications.

V8_Aristo

You might need a more aggressive stance than what the Teins springs can give you. These specs will for sure extend out of the body with a mild drop.

GATO

iTrader: (1)

exactly my next thaught. without the right drop, it will have the illusion of a slight poke.

now, wether you like poke or not. that car will look 10 times better with a mean drop

//935GS400

Thanks for the reply guys. Im gonna get those ssr rims. Since its my daily driver i dont think i can afford my GS being slammed to the ground. But I think its pretty low enough since I got the Greddy lip. If you guys know anyone close to San Diego CA that can do good fender rolls, let me know. Thanks again!

Seize

If you're in San Diego...you can go to either,

Group5 Motorsports and I think AutoFashion does it as well