Help on problem causing fitment problem
#1
Help on problem causing fitment problem
Hey,
I thought I'd post it here because this might give me a better reason. After I put on my rims, i noticed that the passenger rear stuck out about 1/4" from the fender. Odd thing is that the driver side is completely flushed. The offsets are the same, and i'm wondering what could cause this? I've been gettin mixed reasons. One being it's just like that from the factory. Two the frame rails might be tweaked slightly, but was negated by my bodyshop because the suspension/alignment is all fine. Any help with this would be greatly appreciated.
Anthony
I thought I'd post it here because this might give me a better reason. After I put on my rims, i noticed that the passenger rear stuck out about 1/4" from the fender. Odd thing is that the driver side is completely flushed. The offsets are the same, and i'm wondering what could cause this? I've been gettin mixed reasons. One being it's just like that from the factory. Two the frame rails might be tweaked slightly, but was negated by my bodyshop because the suspension/alignment is all fine. Any help with this would be greatly appreciated.
Anthony
#3
turns out the rear passenger fender was pushed in. must've been from the dumpster before i put on my kit. at the time it wasn't apparent because of the stock rims but now i can understand why they weren't the same. well it's all getting fixed now at the bodyshop.
Thread
Thread Starter
Forum
Replies
Last Post
SNiiP3R
GS - 4th Gen (2013-2020)
18
11-06-15 11:43 PM