Does Any Company Make 10mm Spacers For Lexus?
#1
Lexus Champion
Thread Starter
Join Date: Feb 2001
Location: CLUBLEXUS USA
Posts: 3,736
Likes: 0
Received 0 Likes
on
0 Posts
Does Any Company Make 10mm Spacers For Lexus?
Does anyone know a company who makes 10mm (hubcentric) spacers for Lexus? I know there are companies who can custom make spacers but that is like 3x the money with this route.
Last edited by D-MAN63; 03-26-05 at 02:12 PM.
#2
#5
Originally Posted by D-MAN63
Thanks for the website.. Looks like they start off with 1.25" ..
There has to be a company that makes 10mm spacers !?
There has to be a company that makes 10mm spacers !?
#6
Lexus Champion
Thread Starter
Join Date: Feb 2001
Location: CLUBLEXUS USA
Posts: 3,736
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by bluelex
trust me just go the custom route, more money but less stress.
#7
Northern California Regional Officer
iTrader: (5)
Too bad H & R only makes 5mm, 15mm spacers and up.
You could buy the 15mm spacers from H & R and then have a machinist mill off 5mm off from the back. This should cost less than having custom spacers cause you are just paying for the milling process, which is a lot less labor than fabricating the whole thing from scratch.
You can get H & R spaceres here: http://www.optauto.com/index.htm?par...1&deptid=12543
You could buy the 15mm spacers from H & R and then have a machinist mill off 5mm off from the back. This should cost less than having custom spacers cause you are just paying for the milling process, which is a lot less labor than fabricating the whole thing from scratch.
You can get H & R spaceres here: http://www.optauto.com/index.htm?par...1&deptid=12543
Trending Topics
#8
Originally Posted by RMMGS4
Too bad H & R only makes 5mm, 15mm spacers and up.
You could buy the 15mm spacers from H & R and then have a machinist mill off 5mm off from the back. This should cost less than having custom spacers cause you are just paying for the milling process, which is a lot less labor than fabricating the whole thing from scratch.
You can get H & R spaceres here: http://www.optauto.com/index.htm?par...1&deptid=12543
You could buy the 15mm spacers from H & R and then have a machinist mill off 5mm off from the back. This should cost less than having custom spacers cause you are just paying for the milling process, which is a lot less labor than fabricating the whole thing from scratch.
You can get H & R spaceres here: http://www.optauto.com/index.htm?par...1&deptid=12543
Thread
Thread Starter
Forum
Replies
Last Post