Sway Bar end link replacement
#1
Sway Bar end link replacement
Does anyone have any helpful hints on putting new sway bar end links on the front? I attempted to do the job and upon trying to loosen the nut holding it on, it just spins the entire ball within the link. I've sprayed everything with penetrating lubricant with no success. Anybody have any idea how to keep the ball from spinning and get the nut off? Upon fooling with it, I've caused there to be a lot of play within where it mounts, so when I do drive now, I get a lot of clunking where it's metal/metal. So any help would be greatly appreciated! Thanks!
#2
Lexus Champion
there's an allen wrench hole in the front of the bolt idk if you noticed, you're supposed to put an allen in there and then you use an open end wrench to loosen the nut. most of the time though the allen end is completley rusted and trying to get an allen in there without stripping it is a pain, that's why i say just cut the link off completely, that's what i had to do on both ends of my car, it sucks lol.
#5
Saw zaw or cut off wheel.
Steve
Steve
#6
Lead Lap
iTrader: (8)
Is it stripped on the sway bar side or the shock bracket side? If you can remove the sway bar side, then I would recommend removing the shock bracket and cutting it off the car.
I was able to loosen mine a little by hammering a larger SAE allen head socket into the head of the endlink, then after I got some space a I cut it off using a reciprocating saw and sharp metal blades.
If I were to do it again, then I would try using a cut off wheel and cutting a slit into the nut, so I could hammer a screw driver in there and split the nut.
I was able to loosen mine a little by hammering a larger SAE allen head socket into the head of the endlink, then after I got some space a I cut it off using a reciprocating saw and sharp metal blades.
If I were to do it again, then I would try using a cut off wheel and cutting a slit into the nut, so I could hammer a screw driver in there and split the nut.
Trending Topics
#9
I worked on it this morning! Damn what a pain in the butt. I wasn't able to cut it on the side of the nut, So I was using a Roto-Zip and had to cut on the other side towards the boot. When you do it that way, you have to make sure you cut the lip on the link as well otherwise it won't slide through. It took forever, but no more clanking and noises! MAKE SURE TO GET MOOG LINKS. They fit perfect and they are the right size. I originally had ACDELCO (don't ask why), and they are HUGE. Much longer and thicker and don't work at all! I'll be emailing them and informing them of that issue. But otherwise a success. Thanks for the advice everyone. Next will be the power steering rack bushings, any recommendations for brands?
#12
The rear sway bar links are the same setup. I've got a new Milwaukee Diamond Grit 6" sawzall blade. You will need it to cut through the suspension bushings because most of the bolts are rusted inside of every bushing (unless you live outside of the Salted Roads). MOOG parts are twice the thickness of OEM part. I use rockauto.com for most parts
Lexus did not do us any favors with their OEM parts. No corrosion resistant coatings on any exposed parts.
Lexus did not do us any favors with their OEM parts. No corrosion resistant coatings on any exposed parts.
#13
Thread
Thread Starter
Forum
Replies
Last Post