Replacing Master Cylinder Brake Line GS 400
#1
Driver School Candidate
Thread Starter
Join Date: Jul 2015
Location: Oregon
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Replacing Master Cylinder Brake Line GS 400
I was replacing my brake lines to the caliper and noticed the rigid brake line to the master cylinder was leaking as well. I pulled it out but bent the original line since I knew I wasn't going to use it. Now I can't get the line back in. I forgot to take a photo of how the line was routed in the engine bay and I'm not sure if I'm supposed to go over or under the other lines. Plus I'm getting hung up on the springs. Should I pull or unbolt the strut so I have some wiggle room for the new line? Does anyone have a close up they'd like to share? I'd really appreciate it.
One of the bends in the line keeps getting caught on the middle coil.
One of the bends in the line keeps getting caught on the middle coil.
Thread
Thread Starter
Forum
Replies
Last Post
KAJmapper
2Gen GS430 / 400/ 300 Classifieds (98-05)
12
03-25-13 07:10 AM