Help bc racing coil over with trd sway
#1
Help bc racing coil over with trd sway
The car feel very unstable as I hit a dip in the road while driving through a corner. The rear end gets unstable bouncing out of the dip. It gets squirrelly. Has anyone had this issue and what did you do to fix the problem. Alignment is done and within spec beside camber which is -2.5 all the way around.
Bc racing with trd sway bars.
Bc racing with trd sway bars.
#4
Lexus Test Driver
iTrader: (16)
Join Date: Dec 2012
Location: FL, UK & Deutschland
Posts: 1,149
Likes: 0
Received 0 Likes
on
0 Posts
How old/new are they? Do you have the correct preload set? What level of dampening do you have them set to? Was this happening before or after you installed the sways and/or coils? Have you checked the endlinks? Have you checked the sway bar brackets? The control arms? ...honestly, it could be a multitude of things.
#5
Sounds like preload has to be set. When I installed mine, I didn't care if they supposably already had there preload set, I undid all 4, and reset them exactly as should be, and to be honest it seemed as if they were possibly not set tight enough out of the box. I hear people complain about there BC's making this noise that noise, I'll be honest, I don't have ANY of these noises people may be experiencing, make sure you bolts are all tight, and I'd reset that preload if I were you, with an extra 1/4 turn for good luck.
Trending Topics
#14
Driver School Candidate
the only thing I see is that this is not the good kit
I bought a used kit, and i must have for GS300 on GS430
and the rate spring is not the same
i'll change them asap
I bought a used kit, and i must have for GS300 on GS430
and the rate spring is not the same
i'll change them asap
#15
Lexus Test Driver
iTrader: (16)
Join Date: Dec 2012
Location: FL, UK & Deutschland
Posts: 1,149
Likes: 0
Received 0 Likes
on
0 Posts
I'd say your problem is either with your purchasing of used coilovers that are in need of rebuilding, or that you don't have your preload setup correctly.