LS400 rack into SC300?
#1
Pole Position
Thread Starter
iTrader: (1)
Join Date: Jan 2010
Location: Colorado
Posts: 295
Likes: 0
Received 0 Likes
on
0 Posts
LS400 rack into SC300?
Seen so much talk on the ls400 rack into a sc300 for better steering lock/ turn angle. Has anybody done this? I have searched all over and not gotten an specific info on the benefit. Whats the angle diff? Is this mod a bolt on?
Any info would be helpful. I would like to do a good how to and compare on this mod, vs the old setup. Thanks.
Any info would be helpful. I would like to do a good how to and compare on this mod, vs the old setup. Thanks.
#2
Lexus Champion
iTrader: (53)
Join Date: Apr 2008
Location: CA
Posts: 3,240
Likes: 0
Received 0 Likes
on
0 Posts
if you searched you would have found out that the ls400 rack is not bolt on, fully custom.
but there is other cost effective ways around to get more angle
https://www.clublexus.com/forums/dri...ea-thread.html
https://www.clublexus.com/forums/sus...ring-rack.html
as well as cut knuckles
but there is other cost effective ways around to get more angle
https://www.clublexus.com/forums/dri...ea-thread.html
https://www.clublexus.com/forums/sus...ring-rack.html
as well as cut knuckles
#3
Lead Lap
iTrader: (5)
Join Date: Dec 2005
Location: San Diego
Posts: 561
Likes: 0
Received 0 Likes
on
0 Posts
cutting your knuckles and tie rod angle spacers... and the other easy buyable parts will get you more than enough angle. forget about the LS400 rack.
Last edited by BigWaveSC; 02-07-10 at 10:51 AM.
#5
Pole Position
Thread Starter
iTrader: (1)
Join Date: Jan 2010
Location: Colorado
Posts: 295
Likes: 0
Received 0 Likes
on
0 Posts
Nice angle! Can you post a parts list of your spacific mods and a pic of your cut knuckles. Did you have any clearance problems with the suspension? Steering locks? Thanks for the info- in advance.
Thread
Thread Starter
Forum
Replies
Last Post
Ca12los69
LS460 / 430 / 400 / 600h Classifieds
2
11-15-10 09:44 AM