MotoX

iTrader: (2)

Have anyone have this new spring from Tanabe NF210 install in your IS250 RWD?. Please post pictures if you have any. I'm debating if I should put them on because when I received the springs, on the box its say for IS350 not IS250. When I checked there website the parts number for the IS250 and IS350 are the same. For the IS250, they claimed 0.7 all around and for the IS350 like 0.8 front and 1.0 rear. Thanks!!!

VIS250P

iTrader: (1)

Dude, .7 drop all around dont show any drop.. U will waste money to spend for the spring has no drop.. Save money and keep look around instead of NF210 for ISX50 AWD or just wait...

MotoX

iTrader: (2)

No, its for IS250 RWD.

Evil Teo

iTrader: (13)

u might as well get the tein h tech if u dont to lower it that much. better ride quality as some would say.

VIS250P

iTrader: (1)

My mistake... trust me .7 inch drop wont show anything..

mitchsti

iTrader: (1)

I have these springs on my 07 350 , like the stance good ride they have been on fro over 1 year no problems .

mitchsti

iTrader: (1)

sorry its dirty

MotoX

iTrader: (2)

What are the drop? Seem like it lower than 1". Do you have the clunk noises as other have on other brands?

iSuxeL

iTrader: (21)

That's pretty damn even

mitchsti

iTrader: (1)

yes i do get some klunking noises sometimes but not always and after they settled is almost 1.5 inches

MotoX

iTrader: (2)

Anyone else have this springs for there IS250 RWD? Please