Club Lexus Forums - Search Results


Go Back   Club Lexus Forums > Search Forums
Log In 

Showing results 1 to 25 of 66
Search took 0.27 seconds.
Search: Posts Made By: mooseboy84
Forum: ES - 1st to 4th Gen (1990-2006) 03-31-15, 06:48 PM
Replies: 2
Views: 295
Posted By mooseboy84
You can reprogram the keys. I used to have the...

You can reprogram the keys. I used to have the way to do it, it involves putting the new key in the ignition then locking/unlocking doors manually etc. Then it should work. Not very descriptive,...
Forum: ES - 1st to 4th Gen (1990-2006) 07-12-12, 01:48 PM
Replies: 11
Views: 980
Posted By mooseboy84
You can buy a new engine and have it installed...

You can buy a new engine and have it installed for $2000. I would run away quick.
Forum: ES - 1st to 4th Gen (1990-2006) 11-28-11, 10:59 PM
Replies: 7
Views: 1,615
Posted By mooseboy84
http://www.clublexus.com/forums/es300-and-es330/38...

http://www.clublexus.com/forums/es300-and-es330/385166-2004-es330-program-key.html
Forum: ES - 1st to 4th Gen (1990-2006) 11-28-11, 10:55 PM
Replies: 4
Views: 816
Posted By mooseboy84
I dont know anything about electricity, but as...

I dont know anything about electricity, but as far as belt tension, it SHOULD NOT be on so tight that it squeels when you turn wheel or start engine. A good rule of thumb is, when belt is on you...
Forum: ES - 1st to 4th Gen (1990-2006) 11-28-11, 10:45 PM
Replies: 3
Views: 2,091
Posted By mooseboy84
I dont know, but maybe go to www.toyotanation.com...

I dont know, but maybe go to www.toyotanation.com and go on their camry forum and try to get some help.
Forum: ES - 1st to 4th Gen (1990-2006) 11-28-11, 10:38 PM
Replies: 3
Views: 1,168
Posted By mooseboy84
What do you mean the car runs fine for a while,...

What do you mean the car runs fine for a while, then stalls out? What is a while? 10 secs, 10 minutes? Remember a car needs 3 things to run, spark, air and fuel. If its not an electric problem, is it...
Forum: ES - 1st to 4th Gen (1990-2006) 11-27-11, 10:22 PM
Replies: 4
Views: 1,177
Posted By mooseboy84
Reading this and tbe other thread, i think you...

Reading this and tbe other thread, i think you should check your fuel injectors. first off, replacing knock sensors wont make the code stop, unless theyre defective. what knock sensors do, is detect...
Forum: ES - 1st to 4th Gen (1990-2006) 11-27-11, 12:40 AM
Replies: 3
Views: 410
Posted By mooseboy84
Check this thread. ...

Check this thread.

http://www.clublexus.com/forums/es300-and-es330/482145-anyone-have-a-power-steering-diagram-for-a-96-es300.html

I think that pressure hose that goes to fan, is a dealer only...
Forum: ES - 1st to 4th Gen (1990-2006) 11-27-11, 12:03 AM
Replies: 4
Views: 1,290
Posted By mooseboy84
Man, i really, really suggest you get a new...

Man, i really, really suggest you get a new mechanic, like NOW. There is no "timing belt" code that will come up. Whoever your mechanic is, is just some dude trying to scam you and overcharge you for...
Forum: ES - 1st to 4th Gen (1990-2006) 04-27-11, 09:21 AM
Replies: 9
Views: 10,260
Posted By mooseboy84
To do this, you cant use a screwdriver. Well,...

To do this, you cant use a screwdriver. Well, maybe a really big screwdriver. I used my 24" pry bar, which basically is a giant flathead screwdriver, lol. If youre working on this car or any car,...
Forum: ES - 1st to 4th Gen (1990-2006) 04-25-11, 12:18 AM
Replies: 9
Views: 10,260
Posted By mooseboy84
Thanks for the help. I figured it out earlier...

Thanks for the help. I figured it out earlier today and took some pictures.

For those who are not the most mechanically inclined, I took shots for people in the future so they can know where to...
Forum: ES - 1st to 4th Gen (1990-2006) 04-24-11, 08:56 AM
Replies: 9
Views: 10,260
Posted By mooseboy84
I would like to bump this. Im having a horrible...

I would like to bump this. Im having a horrible time trying to get the PS belt back on.

I could not get the PS pump to pivot when taking it off, and ultimately just backed off the crank pulley and...
Forum: ES - 1st to 4th Gen (1990-2006) 03-07-11, 03:25 PM
Replies: 19
Views: 29,077
Posted By mooseboy84
I just want to throw in my thanks as well....

I just want to throw in my thanks as well. Changing any of the rear lights is pretty easy, but I have the haynes 97-01 repair manual [even though I have a 96 es] and it wasnt quite so straight...
Forum: ES - 1st to 4th Gen (1990-2006) 01-19-11, 12:01 PM
Replies: 7
Views: 420
Posted By mooseboy84
http://www.amazon.com/Denso-234-9021-Oxygen-Sensor...

http://www.amazon.com/Denso-234-9021-Oxygen-Sensor-Ratio/dp/B000C5YD42/ref=sr_1_1?ie=UTF8&s=automotive&qid=1295467243&sr=8-1
Forum: ES - 1st to 4th Gen (1990-2006) 09-30-10, 09:53 PM
Replies: 10
Views: 1,420
Posted By mooseboy84
Have you tried Rockauto.com? I got hood supports...

Have you tried Rockauto.com? I got hood supports for about 15 each shipped.

The rightside/passenger side hood lift was easy to replace. The left/driver side has this weird little connector pin of...
Forum: ES - 1st to 4th Gen (1990-2006) 09-30-10, 09:50 PM
Replies: 49
Views: 3,997
Posted By mooseboy84
You must drive slow as hell to get 400 miles per...

You must drive slow as hell to get 400 miles per tank, lol.
Forum: ES - 1st to 4th Gen (1990-2006) 09-30-10, 09:46 PM
Replies: 34
Views: 2,436
Posted By mooseboy84
A car with 7mpg is almost impossible. I knew a...

A car with 7mpg is almost impossible. I knew a guy who had a 62 chevelle with a old nasty 2 barrel clogged carburetor that burned rich, and it got 7-8mpg and weighed 5000 lbs, so I find it hard to...
Forum: ES - 1st to 4th Gen (1990-2006) 09-30-10, 09:35 PM
Replies: 8
Views: 1,481
Posted By mooseboy84
Something is wrong with the camber in the rear....

Something is wrong with the camber in the rear. That tire has a lot of negative camber wear on the inside. Something is obviously bent or broken!

BTW, That tire needs to be tossed and a new one...
Forum: ES - 1st to 4th Gen (1990-2006) 09-06-10, 03:20 PM
Replies: 8
Views: 682
Posted By mooseboy84
Drive slower and carry less stuff in the car.

Drive slower and carry less stuff in the car.
Forum: ES - 1st to 4th Gen (1990-2006) 09-06-10, 03:16 PM
Replies: 5
Views: 502
Posted By mooseboy84
You may want to replace the springs. How does...

You may want to replace the springs. How does your car ride, does it sag down low? Alot of times cars that carry alot of passengers and stuff in the rear will have worn out rear spings. Im getting...
Forum: Car Chat 09-06-10, 03:09 PM
Replies: 74
Views: 65,860
Posted By mooseboy84
Dont mean to revive the dead, but I just would...

Dont mean to revive the dead, but I just would like to add that these instructions worked for my 96 ES300 with the fcc id HYQWDT-B. I bought an extra key off ebay so I could use the unlock/lock...
Forum: ES - 1st to 4th Gen (1990-2006) 08-12-10, 11:24 AM
Replies: 3
Views: 582
Posted By mooseboy84
I need to change my timing belt. Ill pay shipping...

I need to change my timing belt. Ill pay shipping if you send your tool to me, LOL.
Forum: ES - 1st to 4th Gen (1990-2006) 07-23-10, 12:07 PM
Replies: 5
Views: 828
Posted By mooseboy84
Hmm, I havent changed one, but I changed my rear...

Hmm, I havent changed one, but I changed my rear spark plug which was a B I T C H to replace.

Im guessing it shouldnt be that hard to do yourself, but you would need to take off the plenum/intake...
Forum: ES - 1st to 4th Gen (1990-2006) 07-14-10, 10:34 PM
Replies: 5
Views: 1,542
Posted By mooseboy84
Have you tried autozone or kragens? I know the...

Have you tried autozone or kragens? I know the older like post 96 1mzfe have the 3 coil packs with redundant spark, that fire the back 3 cylinders. Im not sure about 94 though, they may have 6 coil...
Forum: ES - 1st to 4th Gen (1990-2006) 07-14-10, 10:25 PM
Replies: 8
Views: 4,256
Posted By mooseboy84
When you change brakes, you really only need to...

When you change brakes, you really only need to change the front brake pads/rotors.

Without know the car history, you probably wont need new rotors. If youre going to a shop, ask them to "turn"...
Showing results 1 to 25 of 66

 
Forum Jump

All times are GMT -7. The time now is 03:11 PM.

Copyright © 2000-2015 Internet Brands, Inc. All Rights Reserved
Privacy Policy | Disclaimer | Terms of Use | JOBS


Get all contact info